Ogre_FL
Well-Known Member
- Joined
- Apr 19, 2019
- Threads
- 11
- Messages
- 177
- Reaction score
- 367
- Location
- Cooks Bayou, FL
- Vehicle(s)
- 2018 JL 2 Door Sport S, 2021 Gladiator 80th
- Thread starter
- #1
Is it just that I am doing a bad job of "pre-alignment" and removals or are the hardtop alignment pins made of a chalk like substance?
I always have to bump/wiggle the top a bit to get some of the pins to fall in the holes and the top to set all the way down.
I have only taken mine on/off a few times now and was surprised to see some of the pins are really worn down already from this.
Should these pins have replaceable plastic covers on them?
I also have had an issue with the drivers side rear pin (or something under there) hanging up when I try to remove the top.
I typiclay have to go inside and lift/wiggle the top for it to free up on that corner, all the other pins/corners come up freely.
I always have to bump/wiggle the top a bit to get some of the pins to fall in the holes and the top to set all the way down.
I have only taken mine on/off a few times now and was surprised to see some of the pins are really worn down already from this.
Should these pins have replaceable plastic covers on them?
I also have had an issue with the drivers side rear pin (or something under there) hanging up when I try to remove the top.
I typiclay have to go inside and lift/wiggle the top for it to free up on that corner, all the other pins/corners come up freely.
Sponsored