Greasing the Seldom Seen Flat Zerk

[XtremeRetard]

Had to remove my Next Venture Motorsports transfer case skid plate. Then the only way I was able to get to the flat grease zerk was to disconnect the driveshaft at the front differential and lift it up as high as possible and tie it to the motor mount. This allows enough space between the u-joints to get to the flat grease zerk fitting. I sure wish Teraflex made a Rzeppa driveshaft for the JL.

Intersetingly Terraflex suggested to me that the JK shaft would fit. I forget the minor issue they mentioned, but in theory it will fit. Hit them up for the details. But I ended up just getting one with the MC lift otherwise I would have tested out the JK shaft..

MC label their JL shaft as JK as well.... so...

Sponsored

 

[EbyCreek]

I agree that the JK shaft should work on the JL. Just hate to spend that kind of money without being sure it would fit. You would think if it fit that Teraflex would tell you that. It wouldn't take much time for someone at Teraflex to put one on and see.

 

[XtremeRetard]

Like I said it does fit.. But whatever you do. Do not ring them and ask!

Sponsored