Jay 13
Well-Known Member
- Thread starter
- #1
Hey all,
So this is a weird one, but figured I’d ask before my OCD drives me nuts and I take apart the tail light to dig into this if it’s not normal.
yesterday while putting gas, I noticed that I could slightly (I’ll show in pic) see the cavity that the pin/notch of gas cover resets into when installed
This being a rubi...This came stock on the rubi, so not something I installed.
Anyone else’s look like this? (where you can slightly see the cavity)
or am I the only lucky one lol?
note it is flush to the body and not a gap as one may think is the culprit as shown in this photo
So pretty confused on what’s the deal.
figured I’d ask, I’ve never noticed it before, so may have always been this way (although I doubt it should be this way)
so again anyone else have this as well? Is it normal? before my ocd drives me to take it off and inspect.
don’t want water getting in there if it will be an issue.
Thanks
Jay
So this is a weird one, but figured I’d ask before my OCD drives me nuts and I take apart the tail light to dig into this if it’s not normal.
yesterday while putting gas, I noticed that I could slightly (I’ll show in pic) see the cavity that the pin/notch of gas cover resets into when installed
This being a rubi...This came stock on the rubi, so not something I installed.
Anyone else’s look like this? (where you can slightly see the cavity)
note it is flush to the body and not a gap as one may think is the culprit as shown in this photo
So pretty confused on what’s the deal.
figured I’d ask, I’ve never noticed it before, so may have always been this way (although I doubt it should be this way)
so again anyone else have this as well? Is it normal? before my ocd drives me to take it off and inspect.
don’t want water getting in there if it will be an issue.
Thanks
Jay
Sponsored
Last edited: