Sponsored

EVO engine/transmission/ exhaust skid with LOD Destroyer sliders compatibility

WagzDad

Well-Known Member
First Name
Carroll
Joined
Oct 19, 2019
Threads
34
Messages
423
Reaction score
508
Location
South Louisiana
Vehicle(s)
2018 JLUR
2018 JLUR with LOD Destroyer sliders presently installed . Will the EVO combination work with it? The area I question is the mounting point on the front left frame. There may be overlap…may use the same hole to attach???

if so:
1. better appropriate product suggestion?
2. stack the mounts?
3. notch exhaust skid and make a new hole?

Thank You!
Sponsored

 
OP
OP
WagzDad

WagzDad

Well-Known Member
First Name
Carroll
Joined
Oct 19, 2019
Threads
34
Messages
423
Reaction score
508
Location
South Louisiana
Vehicle(s)
2018 JLUR
Well, for lack of replies, I ordered the EVO combo. Stay tuned
 

Mattyp1214

Well-Known Member
First Name
Matt
Joined
Oct 27, 2017
Threads
21
Messages
836
Reaction score
608
Location
USA
Vehicle(s)
Black 2018 JLUR
Well, for lack of replies, I ordered the EVO combo. Stay tuned
[Banned Site] had LOD sliders and couldnt install his evo skids until he switched to evo sliders. Its on his evo armor install video
 

Mattyp1214

Well-Known Member
First Name
Matt
Joined
Oct 27, 2017
Threads
21
Messages
836
Reaction score
608
Location
USA
Vehicle(s)
Black 2018 JLUR
Sorry guess that site is banned. Go on youtube and search : Jeep JL Wrangler Skid Plates EVO ProTek Engine Oil Pan and Transmission Protection HOW TO INSTALL
 
OP
OP
WagzDad

WagzDad

Well-Known Member
First Name
Carroll
Joined
Oct 19, 2019
Threads
34
Messages
423
Reaction score
508
Location
South Louisiana
Vehicle(s)
2018 JLUR
Here’s an update on the installation. For the most part it’s pretty easy, except for tightening the bolt in each moter mount. Jacking up the vehicle by the frame on each side helps the access some.

keep everything loose so you can get everything aligned, then work backwards from the exhaust shield to the front of the oil pan. The LCA 190ft# torque is a challenge but doable. Remember that the vehicle must be on the ground for the tighten of the LCA bolt.

As for the interference with the destroyer rails, they use the same hole, so I sandwiched the EVO plate and used a longer bolt with the LOD flag nut.
Sponsored

 
 



Top