Europe Specs Rubicon/Sahara LED tail lights on Sport JL

[Grateful1]

Excellent! I will pull my US spec LED tails out and compare. Thanks!

Would love it if you can get this conversation to work.

Sponsored

 

[hordi]

Any progress? I'll be doing the same stuff...

 

[Bluepencil99]

Any luck with this? Looking to move to Portugal next Summer and would like to bring my Rubicon with me....Need them lights!

 

[Kyanche]

I was looking at this diagram and noticed the euro tail lights have an extra wire from the bcm.
https://www.jlwranglerforums.com/JL-Wiring-Diagrams/STOP-LAMPS-SYSTEM.pdf

 

[ddom]

I was looking at this diagram and noticed the euro tail lights have an extra wire from the bcm.
https://www.jlwranglerforums.com/JL-Wiring-Diagrams/STOP-LAMPS-SYSTEM.pdf

In looking at diagram, I see the Euro Spec version listed. But I noticed the Pin #s are the same for both NA and Euro spec version. (40 & 1) This could be understood that the lighting is BCM controlled. No additional wire needed. An adaptation at the BCM level may be all that is required? Just a question for some that have more knowledge.

 

[operator22]

I’d like to add the export rear fog lights mounted in the bumper Where our reflectors are. Obvious parts are the L/R lights and the light switch. Not sure about harnesses, etc. Anyone tried this?

 

[ddom]

I’d like to add the export rear fog lights mounted in the bumper Where our reflectors are. Obvious parts are the L/R lights and the light switch. Not sure about harnesses, etc. Anyone tried this?

Look here: https://www.jeepgladiatorforum.com/...you-do-to-your-gladiator-today.23705/page-199

 

[operator22]

Look here: https://www.jeepgladiatorforum.com/...you-do-to-your-gladiator-today.23705/page-199

Thanks for that. Also found harness and light assembly part numbers in our forum here: https://www.jlwranglerforums.com/forum/threads/how-can-we-help.6130/post-1262055

That’s a total of four parts including the export light switch. Unknowns are possible connectors and (likely) coding.

 

[ddom]

Thanks for that. Also found harness and light assembly part numbers in our forum here: https://www.jlwranglerforums.com/forum/threads/how-can-we-help.6130/post-1262055

That’s a total of four parts including the export light switch. Unknowns are possible connectors and (likely) coding.

Great! I have been following threads looking for the exact same setup as you for my 2020 JT. Best of Luck!!

 

[operator22]

Great! I have been following threads looking for the exact same setup as you for my 2020 JT. Best of Luck!!

Not sure for the JT but it only fits the molded bumper on JL (same as export bumper).

 

[ddom]

Not sure for the JT but it only fits the molded bumper on JL (same as export bumper).

Agreed. I have a Overland OEM plastic bumper. so JL to JT plastic is good.
Rubis OEM may not work? But if someone wants a decent functioning light assembly, this would work.

Sponsored