JL_John
Well-Known Member
- Thread starter
- #1
Considering upgrading to 40s and full float axles so looking to see if there is any interest in my current setup
Pro Rock 44 front, Rubicon width (67.9) RCV Shafts, 5:13 gears, high caster housing, Eaton locker, new ball joints
Adams 1350 front shaft. Purchased and assembled directly from Dynatrac March 2019. Includes factory knuckles, brakes, and Steer Smarts Tie Rod, Drag Link and Steering Stabilizer relocation brackets
OEM Dana 44 Rubicon rear, 5:13 gears, Mopar diff cover, new chromoly shaft on passenger side. Rear lower control arm brackets are EVO long arm brackets - not stock brackets.
Custom (local made) 1350 rear shaft
Looking to get $5k for current setup. Local pickup in Orange County Ca.
I use my stuff so axles have scratches on them (as they should). Happy to show the setup to potential buyers while its still on the Jeep. Axles would be available early February.
Please DM with questions.
Pro Rock 44 front, Rubicon width (67.9) RCV Shafts, 5:13 gears, high caster housing, Eaton locker, new ball joints
Adams 1350 front shaft. Purchased and assembled directly from Dynatrac March 2019. Includes factory knuckles, brakes, and Steer Smarts Tie Rod, Drag Link and Steering Stabilizer relocation brackets
OEM Dana 44 Rubicon rear, 5:13 gears, Mopar diff cover, new chromoly shaft on passenger side. Rear lower control arm brackets are EVO long arm brackets - not stock brackets.
Custom (local made) 1350 rear shaft
Looking to get $5k for current setup. Local pickup in Orange County Ca.
I use my stuff so axles have scratches on them (as they should). Happy to show the setup to potential buyers while its still on the Jeep. Axles would be available early February.
Please DM with questions.
Sponsored
Last edited: