Djmatt85
Well-Known Member
- First Name
- Daniel
- Joined
- Aug 14, 2018
- Threads
- 9
- Messages
- 233
- Reaction score
- 341
- Location
- Sacramento, CA
- Vehicle(s)
- 18 JL Sahara
- Vehicle Showcase
- 1
- Thread starter
- #1
I’ve started to notice some rattling coming from my slipstream enclosure. I don’t expect a super quiet ride, but geez it’s getting very noticeable. I measured the assembly pins vs. hole diameter and found a roughly 2mm difference. Not a huge difference but not very tight either. I tried shrink tube, tape, etc. but noticed everything would just get gummed up in the panels and make it hard to remove. I ended up 3D printing some sleeves to take up the slop and now everything is nice and snug and still can be removed relatively easily
Does anyone else this same issue? Or am I the only who has the assembly pins rattling around a lot?
Does anyone else this same issue? Or am I the only who has the assembly pins rattling around a lot?
Sponsored
Last edited: