Deleted

[NYLONZ]

sorted

Sponsored

 

[hyon321]

what route did you take?

 

[NYLONZ]

what route did you take?

Ended up purchasing a copy bumper from Poland (with front sensor provisions) - £800 shipped.

This is the best Copy one I've seen as it has the Number Plate Mount.

I would have preferred to have gone OE route however as we all know the Genuine Mopar item does not have sensor holes / provision.

Need to source OE Fender Flares now..................

 

[hyon321]

very keen to know how the fit and finish is. Do you also have a link for it?

 

[NYLONZ]

very keen to know how the fit and finish is. Do you also have a link for it?

https://www.ebay.co.uk/itm/224003073693?ul_noapp=true

I ended up paying £845 Shipped as They offered to supply ex VAT (I'm VAT registered)

I did a lot of research on this, including dealing with the so called 'manufacturers'. As with most Chinese suppliers, they all claim to be the manufacturer but usually they are all made in the same factory & marketed by lots of other sellers.

At least Buying through eBay & paying by PayPal is far safer then dealing direct with the Chinese, if it arrives & it isn't right I'm covered.

 

[lohr500]

I'm watching with interest Nylonz. Please let us know how easy it was to swap over the front sensors once it arrives and you have fitted it. Cheers.

 

[KIVO]

If not too late, would you mind making some close pictures of the park sensor holders supplied with the bumper you ordered Nylonz, as I'm chasing holders I can use for an other bumper?

 

[NYLONZ]

If not too late, would you mind making some close pictures of the park sensor holders supplied with the bumper you ordered Nylonz, as I'm chasing holders I can use for an other bumper?

Will do, expecting the Bumper to Land with me this Thursday

 

[KIVO]

Great, thanks in advance!

 

[Howi]

heads up on PDC sensors, I had them removed from stock to new bumper, they are plastic 'welded' in so not as easy to transfer as pretty much every other manufacturer that just clip in/out !

 

[NYLONZ]

heads up on PDC sensors, I had them removed from stock to new bumper, they are plastic 'welded' in so not as easy to transfer as pretty much every other manufacturer that just clip in/out !

Did you heat them up first?

 

[Howi]

Did you heat them up first?

i didn't do it but yes they heated up, its not that hard but a bit fiddly

 

[NYLONZ]

i didn't do it but yes they heated up, its not that hard but a bit fiddly

Sounds like a job for the missus - she's the one with patience -

 

[KIVO]

Will do, expecting the Bumper to Land with me this Thursday

Any update here (and pictures of the supplied parking sensor holders)?

 

[Overlander21]

I'm eyeing up this Poland bumper too, is @NYLONZ still around? Did you get it installed ok in the end?

Anyone else got one? With parking sensor holes too?

Here's the current eBay link:
https://www.ebay.co.uk/itm/224494042618

Sponsored