03RMK800
Member
- Thread starter
- #1
Hello-
Getting ready to put a Rubi take-off on my 2019 JLU Sahara, including the longer FCA LCAs. From reading the forum, I can't tell if I need to round up a coil spring compressor. Most references I have read talk about blocking the frame, using two jacks, and ratchet straps. Should I get a coil spring compressor before I start?
Also, found a post that a 21mm deep socket and 24 mm wrench are required-- thanks to that poster. Got my air wrench, pretty good range of sockets, wrenches, pry bars, jacks, jackstands, etc. Any other tools suggested?
Getting ready to put a Rubi take-off on my 2019 JLU Sahara, including the longer FCA LCAs. From reading the forum, I can't tell if I need to round up a coil spring compressor. Most references I have read talk about blocking the frame, using two jacks, and ratchet straps. Should I get a coil spring compressor before I start?
Also, found a post that a 21mm deep socket and 24 mm wrench are required-- thanks to that poster. Got my air wrench, pretty good range of sockets, wrenches, pry bars, jacks, jackstands, etc. Any other tools suggested?
Sponsored