Glamisfan
Well-Known Member
- First Name
- Steve
- Joined
- Apr 12, 2018
- Threads
- 9
- Messages
- 532
- Reaction score
- 937
- Location
- SoCal, 30 minutes from Glamis
- Vehicle(s)
- 2020 Sting-Gray JLUR
- Thread starter
- #1
My 39” BFG’s rub on the evap canister. This is my 1st attempt to stop the rubbing. Ignore the stuff peeling off in the pics, it’s Plastidip. 3 nuts to remove. Then there’s an electrical plug on the back. Then there’s a red and green tab that you remove from the 2 hoses, then push in on the gray plastic tab and pull. I jacked the body up and then put a pin bar up in there and let the jack down along with hammering the front mount to get it to fold over. I cut a metal tab to hold the front mount on. A porta power jack would have beven a lot better. A porta power would also let you push the 2 rear studs back some. I picked up 1/2” to 5/8” of clearance.
I’m lower the most with only a 3/8” bump stop extension. And I have roughly 5” backspace (stock wheels plus 1 1/2” spacers). If this isn’t enough I’ll look for a porta power, or could possibly move it under the Jeep?
Anyone else done something similar?
I’m lower the most with only a 3/8” bump stop extension. And I have roughly 5” backspace (stock wheels plus 1 1/2” spacers). If this isn’t enough I’ll look for a porta power, or could possibly move it under the Jeep?
Anyone else done something similar?
Sponsored