Yes, this mirror hack is posted somewhere in this thread.Not reading all the pages but has anybody posted the rear view mirror rotate hack?
Did you just T-Tap it into the footwell led wire? Would like to see a picture.This cost me $10
Wired to footwell light. Turns on with key fob unlock and dimmer switch on dash.
Strip runs along the driver side hood hinge, and under the A pillar panels instead of going through firewall.
I didn't even buy extra wiring, just ran the entire strip down to the footwell, but now I wish I did so I can complete the bottom right corner lol.
It's really not much to look at. Just opened it up and electrical taped it. Red to red, black to black. Taps would have been easier, but it's such a small job.Did you just T-Tap it into the footwell led wire? Would like to see a picture.
being a little off ,and dyslexic with a little a.d.d . i read this asNite Ize Gear Ties. A million and one uses. I have one permanently tied to the middle child seat mount on the rear seats, with a snap shackle.
If the dog is back there, and I want to guarantee that he won't jump out, I'll use the snap shackle on his harness.
But infinitely more useful is using the end of the gear tie to hold open the lid every time I access the rear storage compartment:
I removed my rear view mirror. I did flip it first. My rear tire and Roto-Pax fuel cans block my vision anyways. The Tazer turns on the back up camera when I turn my turn signal on always. Now I have a clear view out the windshield.Not reading all the pages but has anybody posted the rear view mirror rotate hack?
3d print a plugI’ve thought about removing the rear view mirror. It blocks way too much of my forward vision. Any hack for covering up the hole after removing it?
made some of my own as well !!! i need to fine tune then to make them look better
Would share your STL file for this?made some of my own as well !!! i need to fine tune then to make them look better