Huehue80
Well-Known Member
i did put some reflective tape on the plastic near the battery and a little around where you point out, just to smooth off the point. Also I didn’t want to remove the cross member so I just cut out the stock exhaust to install the borla. You don’t have to do that if you install before you get the artec skid. Both are awesome productsFor those of you that installed the borla climber. Did you use any heat shield on, or above, or around where it sits vs. stock position? Wondering if this is needed or not. I’m in Florida and also planning on installing artec skid plates if this has any input into the need or not.
Sponsored