Black Rhino Armory Wheels Rear Camera Options

[Jamitchbikes]

I am looking for options for the rear camera setup with Black Rhino Armory wheels. Any pictures would be appreciated. Going on a JL Rubi 2dr. Thanks

Sponsored

 

[Scarr2k]

Ever figure this out with the camera/brake light?

 

[Jamitchbikes]

Ever figure this out with the camera/brake light?

No I have not

 

[Scarr2k]

I ordered these so hoping to come up with a solution.

 

[Scarr2k]

Wondering if this Iron Cross bracket wouldn’t work with the Armory wheels . Looks like you can push the camera through the “cross” hole in the bracket below the brake light.

Iron Cross Automotive GP-0400 3rd Brake Light Relocation Kit

 

[Stuckinthesand]

I have black rhino Barstow. Not sure if armory are the same but the center cap on mine come off and the camera fits. From looking at pictures of the armory I would bet that center cap comes of also.

 

[Scarr2k]

I have black rhino Barstow. Not sure if armory are the same but the center cap on mine come off and the camera fits.

Thanks! I think the issue some folks have said with the ARmory is the third brake light and how it attaches. I’m going to use the Rugged Ridge Tire Carrier mount so I’ll need to put the brake light above the camera in the middle of the wheel.

 

[Stuckinthesand]

Thanks! I think the issue some folks have said with the ARmory is the third brake light and how it attaches. I’m going to use the Rugged Ridge Tire Carrier mount so I’ll need to put the brake light above the camera in the middle of the wheel.

I’m running a 35 and just used the rough country relocation bracket and extended the tire bump stops on the tailgate. 3rd brake light I just adjusted so it was above the tire. No issues at all with my setup. Not sure if you go above a 35 though.

 

[Scarr2k]

I’m running a 35 and just used the rough country relocation bracket and extended the tire bump stops on the tailgate. 3rd brake light I just adjusted so it was above the tire. No issues at all with my setup. Not sure if you go above a 35 though.

Thanks, I might just wait and see what I’ll need because it might just work doing like you said. I’m planning to run 37’s.

This was the issue that some folks have said:
https://www.jlwranglerforums.com/fo...you-do-to-your-jeep-jl-today.3033/post-835307

 

[df007]

Watching....been curious about these wheels but unsure about the camera.

 

[Reseg]

I have the Abrams (similar), with 37" tires. Using the Rugged Ridge Spartacus carrier system. It sometimes sets off my backup sensors, so I may switch it with something that adjusts higher.
The camera is fine, leaving the center cap off, but the holes in the rim are too small to fit the 3rd brake light plug through, so I had to cut the wires, and use clips. You can see below I taped over the clips with black electrical tape.

I first put these rims on with 35" tires and used the stock tire carrier and it was fine.

 

[Scarr2k]

I have the Abrams (similar), with 37" tires. Using the Rugged Ridge Spartacus carrier system. It sometimes sets off my backup sensors, so I may switch it with something that adjusts higher.
The camera is fine, leaving the center cap off, but the holes in the rim are too small to fit the 3rd brake light plug through, so I had to cut the wires, and use clips. You can see below I taped over the clips with black electrical tape.

Thanks for the info and picture. Very Helpful.
I wonder if the Iron Cross bracket above would work since you might could come out the center hole for both the brake light and camera and then it mounts using the lug nuts.

 

[df007]

I was at the dealer today and saw this Jeep there. Not sure what they did for a third brake light. The camera did not stick out of the deep center very much. This seemed like the -18 offset variant. I have been looking at the +30, so I think the center would be thinner.

 

[Stuckinthesand]

I was at the dealer today and saw this Jeep there. Not sure what they did for a third brake light. The camera did not stick out of the deep center very much. This seemed like the -18 offset variant. I have been looking at the +30, so I think the center would be thinner.

Your probably right. I have the barstows at -18 and just about the same poke. Even though the camera looks pretty deep I only lost a little bit of the red line. I thought I would lose a lot more.

 

[Scarr2k]

thanks for the pics. Just got my wheels delivered today. Prob a month before I can get them mounted with the new tires. Liking them though for the Stingray.

I was at the dealer today and saw this Jeep there. Not sure what they did for a third brake light. The camera did not stick out of the deep center very much. This seemed like the -18 offset variant. I have been looking at the +30, so I think the center would be thinner.

Sponsored