Battle of the Inner Fenders!

[Ryanfold]

Looking for ‘Low on Logos’ and ‘High on Clearance,’ what are you guys using?

I was looking at Ace Engineering, but hear the wheels tend to rub on their design.

Sponsored

 

[melendez69]

Looking for ‘Low on Logos’ and ‘High on Clearance,’ what are you guys using?

I was looking at Ace Engineering, but hear the wheels tend to rub on their design.

I'm an @ACE Engineering fan... no logo, no rubbing, no issues, but I'm on stock 33's. Easy install & I like the giant vent holes. I've seen several others with inners that look fantastic, but the large logos were a deal-breaker.

Go Rhinos bringing up the rear... small, nondescript rhino head logo. Very manly.

 

[Ryanfold]

I'm an @ACE Engineering fan... no logo, no rubbing, no issues, but I'm on stock 33's. Easy install & I like the giant vent holes. I've seen several others with inners that look fantastic, but the large logos were a deal-breaker.

Go Rhinos bringing up the rear... small, nondescript rhino head logo. Very manly.

Thanks for the input, ya Ace’s look is on point, but with 37s and some hard wheeling I’m not feeling confident. Maybe another 37 can chime in and help me make a decision.

Ill check out rhino’s too! Thanks.

 

[AMC_CJ]

I'm between the Artec, and Road Armor... my ultimate decision will probably depend on if I go with the Road Armor fender flares or not (also considered a chop kit instead).

 

[Headbarcode]

I'm very happy with the AAL liners, and other parts of theirs. I don't like obnoxious branding, like everything from dv8, and I didn't want venting.

 

[Ryanfold]

I'm very happy with the AAL liners, and other parts of theirs. I don't like obnoxious branding, like everything from dv8, and I didn't want venting.

I’ve had an amazing experience with AAL so far too. Ill look at those.


Are you on 35s or 37s?

 

[Centurion07]

Thanks for the input, ya Ace’s look is on point, but with 37s and some hard wheeling I’m not feeling confident. Maybe another 37 can chime in and help me make a decision.

Ill check out rhino’s too! Thanks.

37s and @ACE Engineering - zero issues.

 

[Headbarcode]

I’ve had an amazing experience with AAL so far too. Ill look at those.


Are you on 35s or 37s?

38's and about 4" of Metalcloak Gamechanger flex. From what I've seen, AAL liners are amongst the highest as far as tuck. Artec was the only others that blipped my radar, due to their equal high tuck design and minimalistic branding. I chose the satin black powder coat finish that AAL offers. Gloss black would've visually stuck out more than I like and the textured finish seemed like it could hold mud more easily.

 

[Dr3wDrop]

I have a set of JCR Fender liners listed in the market place. I think they look sharp, I just want to go with the plastic route.

Sponsored