Ethan
Active Member
- First Name
- Ethan
- Joined
- Jul 14, 2018
- Threads
- 4
- Messages
- 40
- Reaction score
- 99
- Location
- Point Reyes Station
- Vehicle(s)
- 2018 Jeep Wrangler Rubicon JLU
- Occupation
- Metal Fabricator & Stuff
- Thread starter
- #1
Hey Jeepers,
So I have a JLU Rubicon with factory installed Aux Switches. The switches are enabled in the Uconnect system and I have selected Latching function and Battery as source. I know where the wiring stubs are and have wired Rigid 2" cubes up to them, but no go-polarity correct-tried both ways anyway. Aux switch lights activate upon selection, but no juice at either the passenger footwell or battery wire stub locations.
So, question: Even if I have the factory installed Aux Switches, they are configurable in Uconnect, and the switch indicator light comes on, do I need to go to the dealer for something???
Lastly, I have a TAZER JL and have selected both YES and NO to Aux Switches, but this has done nothing to enable the juice to flow to the wire stubs.
Any ideas?
Thanks!
Ethan
So I have a JLU Rubicon with factory installed Aux Switches. The switches are enabled in the Uconnect system and I have selected Latching function and Battery as source. I know where the wiring stubs are and have wired Rigid 2" cubes up to them, but no go-polarity correct-tried both ways anyway. Aux switch lights activate upon selection, but no juice at either the passenger footwell or battery wire stub locations.
So, question: Even if I have the factory installed Aux Switches, they are configurable in Uconnect, and the switch indicator light comes on, do I need to go to the dealer for something???
Lastly, I have a TAZER JL and have selected both YES and NO to Aux Switches, but this has done nothing to enable the juice to flow to the wire stubs.
Any ideas?
Thanks!
Ethan
Sponsored