Cypher
Well-Known Member
- Thread starter
- #1
After a long wait, my Punk'n JLUR arrived. This will be more of an overlanding build than a rock crawler, so the plan is to build for function and protection. My wife and 8yr old daughter love to explore, so we plan on a lot of trail time.
So far I only have the floor mats in and installed, and a VIAR 450p auto portable compressor with ARB deflator. Rhino recovery strap and d rings.
Parts already purchased to be installed:
Roam Frame mounted Rock Slider / Steps
Metalcloak Undercloak full underbelly skid plates
Metalcloak rear differential skid plate
Rancho front differential skid plate (will swap to Metalcloak once it is offered)
Rock Hard Lower Control Arm skids
Mopar JL grill / winch protector / bar.
Mopar grab handles for front and rear
Mopar door sill guards.
Parts I am planning to order:
6" or 7" Round LED lights for front bumper winch / grill guard.
Warn Zeon or Smittibilt X20 comp winch
Warn winch plate
Factor 55 link
35" tires (K02 or Ridge Grapplers)
Falcon 3.3 shocks
CB of some sort.
Falcon 2.2 or Fox ATS stabilizer. (Once there is a skid for it, or model that supports relocation)
Aftermarket front and rear bumpers. (Holding out for the Rugged Ridge SEMA front bumper)
Depending on how it does, maybe a small lift with Teraflex Alpine flex arms. (However, mine sits 100% level with no rake at all. With 2200 miles it has about 39 3/4 in to bottom of fenders as is. About 8 inches above tire to outside, and over 9 in inside.)
Here are a few pictures as is today before the mods come in. Still plenty capable, and we will use it to explore all over the 4-corners states and CA.
So far I only have the floor mats in and installed, and a VIAR 450p auto portable compressor with ARB deflator. Rhino recovery strap and d rings.
Parts already purchased to be installed:
Roam Frame mounted Rock Slider / Steps
Metalcloak Undercloak full underbelly skid plates
Metalcloak rear differential skid plate
Rancho front differential skid plate (will swap to Metalcloak once it is offered)
Rock Hard Lower Control Arm skids
Mopar JL grill / winch protector / bar.
Mopar grab handles for front and rear
Mopar door sill guards.
Parts I am planning to order:
6" or 7" Round LED lights for front bumper winch / grill guard.
Warn Zeon or Smittibilt X20 comp winch
Warn winch plate
Factor 55 link
35" tires (K02 or Ridge Grapplers)
Falcon 3.3 shocks
CB of some sort.
Falcon 2.2 or Fox ATS stabilizer. (Once there is a skid for it, or model that supports relocation)
Aftermarket front and rear bumpers. (Holding out for the Rugged Ridge SEMA front bumper)
Depending on how it does, maybe a small lift with Teraflex Alpine flex arms. (However, mine sits 100% level with no rake at all. With 2200 miles it has about 39 3/4 in to bottom of fenders as is. About 8 inches above tire to outside, and over 9 in inside.)
Here are a few pictures as is today before the mods come in. Still plenty capable, and we will use it to explore all over the 4-corners states and CA.
Sponsored
Last edited: