Anyone know how to depin this connector?

[Bluebeast]

I've already slid the white locking tab over but the wires still don't want to move. Any suggestions?

Sponsored

 

[Bluebeast]

Never mind figured it out!

 

[americonium]

I would be so swell if you'd share so if someone searching for the answer comes across your thread, they would find out as well.

 

[Bluebeast]

Lol. After sliding the white locking tab over, I used a seam ripper (only pointy sturdy thing I could at the house that was small enough) to slide into the small hole to push down the retaing pin and then they just slid out the back with a little tug. Hope that helps. Im pretty sure they make an actual tool for it but I didn't feel like driving to the store again.

Sponsored