Dreadnought_Leviathan
Well-Known Member
- First Name
- Robert
- Joined
- Jan 8, 2018
- Threads
- 30
- Messages
- 307
- Reaction score
- 329
- Location
- Dallas, Texas
- Vehicle(s)
- 2018 Jeep Wrangler Unlimited Rubicon
- Occupation
- Finance
- Vehicle Showcase
- 1
- Thread starter
- #1
Because mine sure as hell did! It melted so bad and messed up the entire bracket that was installed in the rear bumper. Jeep replaced it under warranty, thankfully. However, after getting it repaired, it did it again!
The service guy at the dealership said that there's a small circuit board attached to the rear left break light that shorted out and caused the melt the first time. I think it did it again. Probably because they installed the same exact part.
I'm gonna take it back it to get it fixed, but I wanted to see if anyone else has had this issue.
The service guy at the dealership said that there's a small circuit board attached to the rear left break light that shorted out and caused the melt the first time. I think it did it again. Probably because they installed the same exact part.
I'm gonna take it back it to get it fixed, but I wanted to see if anyone else has had this issue.
Sponsored