Anyone add an exhaust tip? (Or entire new exhaust)

[JeepJL18]

I was thinking about adding one of these on mine as I don't like the plain ass tip on there now.

Anyone add something like this or a new exhaust?

Sponsored

 

[Solaris13man]

I was thinking about adding one of these on mine as I don't like the plain ass tip on their now.

Anyone add something like this or a new exhaust?

I swapped out for an AFE Cat Back Exhaust

 

[JeepJL18]

I swapped out for an AFE Cat Back Exhaust

im jealous. My wife would kill me. LOL

 

[Solaris13man]

im jealous. My wife would kill me. LOL

It sounds fantastic and the cost was reasonable. It’s not overly loud but gives the exhaust a deeper growl

 

[Meatwad]

I installed a Flowmaster Force II catback exhaust. (pics below) Super easy install btw. Just be prepared to give your pound of flesh getting the OEM exhaust off the hangers.

Its a bit loud with the softtop, but I love it and the other end can't hear it if I'm on a call. To my surprise my wife doesn't feel like its too loud, so I'm in good shape. Its sounds great going through the gears (I have a manual) and at low RPMs, below say 1,200, it lets out a super low tone that sounds like a big V8. Ran about $500 with me doing the install.

 

[pjs1inc]

How long did it take you to install it?

No welds, on factory or aftermarket, right?

Can a average Joe install it? One man job?

TIA

 

[JIMBOX]

DYNOMAX TURBO

W.E.

JIMBO

 

[Djmatt85]

I did a muffler delete and installed an AFE high tuck axle back exhaust ~$200. Sounds great and not too loud. But, it all depends on personal preference in terms of desired loudness.

 

[Jo's Jeep]

Looking into this...
Flowmaster 817837 2.5" American Thunder Axel Back System for 2018 Jeep Wrangler JL with 3.6L

 

[Bubba33]

How long did it take you to install it?

No welds, on factory or aftermarket, right?

Can a average Joe install it? One man job?

TIA

Here is a tip spray the rubber hangers with wd40, they will slide off allot easier. Should not be hard to install at all.

 

[Djmatt85]

Here is a tip spray the rubber hangers with wd40, they will slide off allot easier. Should not be hard to install at all.

+1
Yes, lubrication is key. Lol

Most kits I’ve seen do not require welding and can be done fairly easy by one person. I had mine installed in about 30 mins.

 

[Jo's Jeep]

If you use a small "tweeker" screwdriver and gently pry the rubber (don't gouge it) and squirt the WD40 in there it works like magic.

 

[Redjl20737]

Will the cat back good waranty !?
That’s all I’m worried about

 

[RubiRob]

I like this one just because its much less likely to get smushed by anything out on the trails:

 

[namodei]

I added the Gibson single exit exhaust. Also available in black. Sounds great!!

Sponsored