NorthernYankee
Member
- Thread starter
- #1
My current setup consists of the following
OEM 8.4"
RF DSR1 being used strictly for Preamps
Helix DSP.2
Alpine PDX-V9
Morel Maximo 6.5 Components in the stock knee and Dash location
Morel Maximo 6.5 Coax in the sound bar
JL 13TW5v2 in a custom fiberglass enclosure
I currently have the Amp and DSP mounted under the driver seat and its ok but I have decided that I want to move it to the back. I like to keep everything very neat and tidy so I am trying to think of the best way to bring all of my wiring the bin with the minimal amount of cutting yet still keeping it under the factory trim. In the pic that I attached put red arrows pointing to where I would trim which is marked in yellow and then under the tie dawn bracket. I am thinking power and ground to the driver side and RCA and Speaker wires to the Passenger side. But I am not sold on that Idea...I would really like to come in from underneath so I can hide all of the wiring but I don't know how I would get all the wiring back inside the Jeep.
But I am looking for ideas and suggestions on what everyone else has done or any ideas on how they would do it. I am completely open to doing it completely different from what I am thinking.
OEM 8.4"
RF DSR1 being used strictly for Preamps
Helix DSP.2
Alpine PDX-V9
Morel Maximo 6.5 Components in the stock knee and Dash location
Morel Maximo 6.5 Coax in the sound bar
JL 13TW5v2 in a custom fiberglass enclosure
I currently have the Amp and DSP mounted under the driver seat and its ok but I have decided that I want to move it to the back. I like to keep everything very neat and tidy so I am trying to think of the best way to bring all of my wiring the bin with the minimal amount of cutting yet still keeping it under the factory trim. In the pic that I attached put red arrows pointing to where I would trim which is marked in yellow and then under the tie dawn bracket. I am thinking power and ground to the driver side and RCA and Speaker wires to the Passenger side. But I am not sold on that Idea...I would really like to come in from underneath so I can hide all of the wiring but I don't know how I would get all the wiring back inside the Jeep.
But I am looking for ideas and suggestions on what everyone else has done or any ideas on how they would do it. I am completely open to doing it completely different from what I am thinking.
Sponsored
Last edited: