mackh4x0r
Well-Known Member
- Thread starter
- #1
Hey. Just went on the beach today and engaged 4wd and all was good. A moment later my dash flickers and says the transfer case is in N. I get into thick sand and can tell I'm driving in 2wd drive. I turn off/on the engine, it's still flickering. Put it in 4 lo and my tires don't spin at all.
Put it in 2wd, swap back to 4wd, and it stays in 4 for about 30 seconds. Managed to get off the beach without getting stuck.
I have a rear axle on order for the axle locker issue. I called the dealer and he says it may be related. But I've been on the beach several times without any issues.
They replaced a transfer case switch awhile back. What could be causing this? I'm on vacation but once I get home, I'll see what the part number they replaced.
2021 Rubicon manual
Put it in 2wd, swap back to 4wd, and it stays in 4 for about 30 seconds. Managed to get off the beach without getting stuck.
I have a rear axle on order for the axle locker issue. I called the dealer and he says it may be related. But I've been on the beach several times without any issues.
They replaced a transfer case switch awhile back. What could be causing this? I'm on vacation but once I get home, I'll see what the part number they replaced.
2021 Rubicon manual
Sponsored