I thought I did, at first, but now I can’t tell.Can anyone running 35 inch KO2s speak to any power loss on a v6 automatic?
probably ok on a rubi with 4:10 but sport or sahara with 3.56 would be a bit sluggish, I initially had a sahara with manual and stepped up to 33s and it was fine but any bigger would have felt a bit slowThe same question but for the 6 speed manual...noticeable power loss?
@LBK454 , what 1" Teraflex spacer did you use? I see 1/2 ones, and 1 1/2 in ones but can't find a JL 1" for the front.Another. There is very little rake - the camera angle of above pic seem to show a lot of rake.
Ok, so if i i buy the 2door 1.5" spacer lift it has the 1" front and will just need the .5 rear. That is good information for anyone wanting to run 35s without a full 2" lift. I have a 2" lift to install, but debating on just doing something like this with good shocks until ai know for sure this JL is a keeper.I went about it in a more convoluted way and it cost me a bit more to get what I wanted. I couldn’t find a 1” spacer that I liked, so I ended up buying the Teraflex JL 1.5 lift for the 2 door JL. That had a 1” front spacer and a 2” rear. I used the 1” front and bought the 1/2” rear. I did end up with their Flacon bump stops (and a left over 2” rear spacer) but I haven’t needed to use the Falcon bump stops. FWIW I think a company called Traxda will make a 1” front spacer.
I have 37 x 12.50 on stock rubicon rims, nearly 8,000 miles. No problems at all. 4 Wheel Parts mounted no problem. Drives better than stock on the Freeway ( front lower adjustable control arms, Yeti sway bar, Fox Steering Stabilizer). Also it has been on the Rubicon Trail and the Pismo Dunes. Should be no problem finding a shop to mount them. PM me if I can assist , provide assistanceAs many people of mentioned, shops will not mount the 35x12.5 on the factory rubicon wheel. For those that are running 35s on the factory rubicon wheel, have you had any issues? There’s obviously a reason they refuse to mount them so I’m wondering if anyone has actually experienced any problems... thanks!
I have 37 x 12.50 on stock rubicon rims, nearly 8,000 miles. No problems at all. 4 Wheel Parts mounted no problem. Drives better than stock on the Freeway ( front lower adjustable control arms, Yeti sway bar, Fox Steering Stabilizer). Also it has been on the Rubicon Trail and the Pismo Dunes. Should be no problem finding a shop to mount them. PM me if I can assist , provide assistance