2” front 1” rear coil spring level

[Derosier78]

Just purchased 2” front,1” rear coil “level” kit. Full coils not the spacers. Should I add anything else on the front suspension? I don’t think an inch in the rear is enough to worry about adds. Thanks in advance.

2021 JLU Willys

Sponsored

 

[NewJLU2019]

The wife Sahara has the Teraflex spacer 2" front to remove the factory rake and 1" rear to level out. The tires are 33's. Better lift for light off-road.

 

[Derosier78]

Thanks! That’s exactly what setup I’m looking for, I just read a bunch of threads on how track bar extensions, upper, lower control arms are needed for the extra 2” on the front. You didn’t add any other component modifications?

 

[Zandcwhite]

Front lca's as caster will be on the low side. Mopar extended lcas are under $100 and well worth it for even stock height rubicons.

 

[Derosier78]

The wife Sahara has the Teraflex spacer 2" front to remove the factory rake and 1" rear to level out. The tires are 33's. Better lift for light off-road.

Thanks! That’s exactly what setup I’m looking for, I just read a bunch of threads on how track bar extensions, upper, lower control arms are needed for the extra 2” on the front. You didn’t add any other component modifications?

 

[Derosier78]

Front lca's as caster will be on the low side. Mopar extended lcas are under $100 and well worth it for even stock height rubicons.

Probably should add to the factory bump stops as well.

 

[NewJLU2019]

Thanks! That’s exactly what setup I’m looking for, I just read a bunch of threads on how track bar extensions, upper, lower control arms are needed for the extra 2” on the front. You didn’t add any other component modifications?

I didn't have to add anything else. Drives great and handles well.

 

[Kleiss1]

Isn’t there a spacer there already? Do you leave it or pul it out? Thanks

 

[Derosier78]

Isn’t there a spacer there already? Do you leave it or pul it out? Thanks

In my case I’m replacing the factory coil with one that is 2” longer, not adding a spacer. so I will not have an existing spacer to remove.

 

[Zandcwhite]

In my case I’m replacing the factory coil with one that is 2” longer, not adding a spacer. so I will not have an existing spacer to remove.

I think he's referring to the coil isolator at the top, which is reused with aftermarket spacers typically.

Sponsored