Sponsored

camshaft

  1. JL Issues after replacing camshaft and rockers

    My jeep (2018 JLUR) has been having some intermittent issues since I completed the camshaft and rocker replacement. I did an exploratory search of the cams and rockers after hearing the ticking noise and getting a cylinder 5 misfire code. My right intake camshaft had the most wear on the last...
  2. P0300 MISFIRE - COLD START STUMBLE BUT DRIVES/REDLINES FINE

    2018 Wrangler JLU - 67,000 Miles - 3.6L Automatic ** UPDATE 08/14/25: Got worse, Coolant tank is empty. Bore scoped the cylinder to find a pink pool! Head gasket job next. Ill keep updating this thread. **UPDATE 08/04/25: Used Jscan to do a CAM RELEARN and clean Cam Phasers, Replaced Cyl3...
  3. 2024 jeep 3.6 camshaft

    Hey guys, I have a 2024 jeep willys with 3.6 that is less then a year old with roughly 36 000 kms on it. The engine light came on the other day and took it to the dealership and was advised that it was the camshaft. Car has been there for roughly 2 weeks now and the part is back ordered. Other...
  4. 3.6L Cam Swap Parts Links & Info

    Hi Guys, I'd like to post this thread as a resource for the DIY guys who need to tackle a cam or lifter swap on their 3.6L. This information covers the 2018-2025 JL wrangler and JT Gladiator as well. As for the repair there are many excellent Youtube videos available that explain each step...
  5. Cam issues

    Hi there! I have a 2020 wrangler sport altitude, I had one of the camshafts replaced around the 50k km mark. Recently I heard the same dreaded tick, took it to the dealer and sure enough that same cam needs to be replaced again after 26k km. The dealer said that there is now a bulletin out on...
  6. Emotional Damage - 3.6L Engine Knock/Tick

    I've just developed a knocking noise and it came in aggressively. I relocated from Texas to Denver, Colorado on a 4 day road trip. Passing through New Mexico I noticed a noise. After settling in and cruising around Denver I noticed something much louder and repetitive. Listen to the videos...
  7. Cam shaft position sensor - code po345 & po390

    Hello, A few weeks ago I got those two error codes and took it to the dealer yesterday to get it looked at. During the time the codes were on it felt like there has been a slight loss of power, but I am not completely sure. It also seems to idle a bit rougher and sometimes gives a slight knock...




Top