I keep reading different numbers about the M200 axle, such as tube thickness, spline count and axle shaft diameter. Are there factory spec sheets anywhere? How do they differ from the M220 and JK D35? Is the m200 a c clip? Is the m186?
Thanks
Is there a way to do this without taking the wheels off? Or is that the only way? I was reading a spring compression tool can be used but they seem sketchy. Will the steering need to be adjusted if I add a 2 inch spacer to front only?
Installed steel front bumper and winch a while ago, front sag is very annoying aesthetically. Wanting to put these 2 inch spacers just in front (https://www.extremeterrain.com/rubicon-express-2-front-coil-spring-spacer-lift-kit-0718-jk-2018.html#customer_reviews). I know Jeep has front sag from...
Vehicle rides well. I have 8.9 front and 10.0 rear shock travel with fox 2.5s from mopar kit. Just trying to level out my vehicle from the extra weight on the front. Do you think it'd make sense to put spacers in the front or install a steel rear bumper to even out the weight?
Have you had any problems with them? I've been debating getting them but saw a lot of bad reviews about the lights fogging up and rocks going through the fenders from driving on gravel
Got 2 inch mopar lift. I’m trying to figure out if I should go for 1 inch in the front or 1.5. I’m also trying to figure out if I can do this with a scissor Jack and a hi lift (I just replaced all 4 shocks with only these tools).
Is it bad to run spacers only in the front to compensate for the...
Added a steel bumper and winch combo a while ago, definitely noticing around a 3/4 inch sag in the front. I want to add spacers to the front suspension, are there any you'd recommend? Is this install relatively easy?
Or should I just go with a metal rear bumper to try and even it out?
Is the shake you have currently occurring consistent whether you are moving or not? Because if it happens while you're not moving I'd think it is clearly not the tire/wheel/suspension? How big was this "pothole" you hit? Do you have any error codes?
If it is happening only while your moving I'd...
Getting a consistent high pitched whining noise. At high speeds (70+) under acceleration it is super loud. at low speeds during acceleration and deceleration it is less noticeable, but still makes a lot of noise. 3.45 ratio, BFG ko2 35x12.5r17, method 305 and 60k miles. Is this the transmission...
Hm I'm going to have to try this. I went to the dealer to get the PCM updated with TSB 18 092 19 but they said it was already done. Not really sure why it wouldn't start if that TSB was already run...
Just can’t justify the price/insurance cost of the 392 so I’m debating getting a current gen rubicon V6 - but the full floats on the 24 are tempting enough to make me wait. Anybody got any idea as to the specs or strength of them? Does them being full float mean it’ll have hubs where the axle...