I would love that. The only issue I can think of is that the way the current bench seat is secured involves the anchor points on both the far left and right sides of the cab. They would need to add another central row of anchor points somewhere in the middle of the cab for the bracket of each...
Just finished a weeks-long project of adding an XR takeoff suspension (small lift), wiring new half doors for passive entry, and wiring up show lights for Jeep Beach.
Technically the others that said "stock" are correct, but I don't think your question makes much sense. Backspacing dictates how far in or out of the wheel well your wheel sits. Lifts make the body of your vehicle sit higher. There's no conflict of space there.
The only time backspacing...
It's pretty painless. There are two stickers on the edge of the door - The top one locks your handle in place, the bottom locks the key cylinder in place. Loosen the bottom bolt (T25 I think) and the cylinder drops right out.
Keying a new cylinder yourself is a bit tedious, but perfectly...
Yea it comes off pretty easily. The kit comes with two lug nuts that have threaded holes in the ends. You screw the two bolts into the brake light holder, and plug in the light. Takes 2 minutes.
I think this should do the trick. It's wider than the camera is before heating, and can shrink and seal the entire hole easily. You may have to trim a bit if the camera gets covered up, but that shouldn't be too challenging - just trace the groove with a fine blade and peel gently.
Amazon.com...
Oof, $1800 is robbery for that. It's not special just because it came off a 392. Don't waste your money dude.
Any Rubicon suspension you can find for $100-200 will get you 1.5" give or take depending on what it came off of (heavier takeoff vehicle = stiffer suspension for you).
Dude I would honestly keep the rear seat in ours if it stayed in place when you folded it forward. We rarely need the entire back free for a load of groceries or whatever else we throw back there, but having the seat flopping up and down is just annoying.
Ah yea, you're right. It looks like the 4-door version has to accommodate the 60/40 fold down whereas the 2-door rear is just a single piece. Bummer! :(
Rear Bench Tactical Seat Covers for Jeep Wrangler JL 2018-24 2 Door Bartact w/ MOLLE | Bartact
Oh dude, the Teraflex carrier has a separate swing arm that comes with it (assuming you mean the Alpha HD Carrier):
We have that same carrier on ours, and yea the factory swing arm does not work with it. Teraflex customer service is great if you need one.
Did you install a reinforcement bracket or anything where you would have loosened the outside hinge bolts? Apart from changing the swing arc of the tailgate significantly, there's no reason the factory one should fail. Is your checkstrap still attached too?
Does anyone happen to know the part number for the front sway bar end links that come with the XR package? One of the studs is spinning in place in our kit, but I'm not able to find the exact ones online. The ones I have are ~6.5" from stud center to eye center, but all I can find are:
7.5" -...