Quick update. PAC recommended that i replace the amppro and that it might be defective. Did that today and same result. so its either source or the amp.
Wish I could bring it to you to check out! Ha. Not familiar with gain mismatch ?
I did the install. Was fairly simple - I've been doing my own for easily 20 years and this is the first time I've ever had a problem like this.
I'll see if I can find someone local to dig in to this issue for me.
Just installed 5 channel amp (Kenwood XR900-5), subs (JL CP208LG-W3V3), and PAC AmpPro. I have the 8.4 with factory alpines. I planned on using factory speakers for now.
I'm getting some major crackling and distortion when I turn the volume mid way or so and have to turn the gains way down to...
All, I've been reading this thread for a while. I have a question about the PAC route. If I go this route, do I need to run speaker wire to each speaker I want to power with my 5ch? Or does the harness handle that for me?;
Looking at the idatalink maestro also, which may be my solution but...