Thanks so much, your pictures are exactly what I needed. I can clearly see the slight increase in width, without protruding beyond the flares, very nice. Iāll get them ordered tomorrow, as well as the spare tire kit.
Do you notice any difference in performance with the added weight of the larger...
Thanks, Iāll be using my stock OEM wheels, so they should not protrude. Iāll just have to deal with speedometer recalibration, and if the spare will fit without contacting the bumper, as it is now, thereās a little less than 3/4ā from the bottom of the tire to the bumper, so itās likely going to...
Hello all, I have a 21 Rubicon, Iād very much appreciate photos of BFG All Terrain 315/70-17ās down the side on stock Rubicon wheels. Iād like to see if they protrude beyond the fender flares.
Thank you
I have these in my rear bumper, very bright, I have them wired to Aux4. I flick them on and off, theyāve been totally effective in getting those behind me to dim their brights.
Removed from my 2021 Rubicon at 250 street miles.
Two door version, hardware included. I will ship only if you are willing to accept the cost, they are properly packaged and ready to go.
Brand new, never mounted Mopar OEM running boards for 2 door JL. I changed my mind after I had them a couple weeks, nothing wrong with them.
Free shipping to U.S.
Just for reference, this is a spacer lift on stock 33ā tires. I just did mine yesterday, took about 5 hours in my garage. TeraFlex 1.5ā spacer lift (actually 1.5ā rear, 1ā front) with Falcon shocks. I got a great deal from a forum member who decided to go with 37ā tires.
Thanks, I laid on my back for about 30 minutes pondering different routes to the retaining screws, but in the end it was worth it to me, as I just didnāt want to deal with bumper removal.
The worst part of the entire process was smacking the driverās side light with a rubber mallet š³ but it worked.
I have the steel bumper (that I did not remove) with a MagnaFlow dual outlet exhaust like yours...it did not interfere with the removal or installation.
I wired them the same as āRobAmyā, connected the grounds as one, then grounded to the frame at the rear. I connected the power wires as one, and used flexi tubing inside the passenger frame rail to an opening near the front wheel opening, then up to the auxiliary wiring harness, using the...
Finished them last night, took awhile to route the power wire to the auxiliary switches harness under hood, as Iām anal, and was very careful how I routed it using flexi tubing. Looks very nice, too bad itās not visible...lol.
So, connected solely to Aux4, and they are bright! The backup camera...
I just installed mine on a 2021 Rubicon with steel bumper. I did NOT remove the bumper, I used a long extension with a 1/4ā socket running over the top of the bumper assembly with near straight access to both screws, and turned the screws out by hand.
I used a magnetic work light to illuminate...