Search results

Pm me your printer and filament type and I’ll send gcode.

3D print your own (caps). https://www.jlwranglerforums.com/forum/threads/3d-designer-section-for-3d-printers.79770/post-1722385

Check the PDF description in the post by @Mike_Darko

My mill is still set up, bring ’em over. (See post above yours. ) Most people use their winch to bring their Jeep to a tree. I use the winch to bring trees to the Jeep.

I tow my sawmill. Roughly 1500 lbs, 150lb tongue weight and ~24’ from ball to tail lights.

I have a center channel that they slip in. 3mm over on the front side, 3mm over on the back side, and a 0mm abutment through the center. They’re TPU, so they give enough to squeeze in, but aren’t going anywhere once they’re in.

This isn't tech support for Teyes. This is a Jeep Wrangler forum. Asking about the specifics of canbus module for your Suburu here, of all places, is certain to lead to incorrect settings. It's a buggy piece of hardware even when it's working as advertised. Getting Teyes advice for your...

Added some 3D-printed white bling to my new bumper. Those 5 circular openings just needed "something." Before: And after adding some TPU-printed bling (the 5 white rings):

Got a good deal on new-in-box-lacking-mounting-brackets deal on a Barricade Trail HD from Extreme Terrain. I cut my own brackets on the plasma cutter and welded up my own mounting brackets. Followed up the install by adding a Zeak winch and some 3D printed bling on the lower openings as well.

Thanks @Radave - when taking my doors off this Spring I found the same thing that you did - that the "Acc off" only option wasn't available anymore - likely due to the firmware update that was pulled down since last year when I had posted success with the doors-off setting (see bullet #2). I...

Welcome to the bright white Club.

Mine didn’t last 3000 miles. The Auto SS was disabled because the battery was charging forever. Both batteries tested faulty and were replaced under warranty.

Just a heads up on firmware update from January - CC3: 1. Officially released TEYES YAHU music player.View 2.In CC3 regular theme UI, the Spotify switch button is added to facilitate users to perform Spotify app control directly on the main interface such as Toggle, control, etc., and...

pm sent

I use FreeCad. Pix of the lights would be the best way to assess, but a ffriction-held TPU cover design and a pair of calipers would be where I'd start.

pm sent.

If that's the rear-view mirror cluster (you have lane tracking?? mine has open space behind it where I have a dashcam mounted), then that looks to be (again, just judging from the image because I'm a Sport S guy) a plastic quick fastener that releases on just a quarter turn of the Phillips head...

The compression clamp is really tight, but not so tight that the holder can't be mounted/removed in less than a second. ;) An anal-retentive OCD-type person might design a TPU (rubbery, flexible filament - like I used for the lugnut caps) covering for inside of the clamp jaws that would take...

With the kick panel in place. Blinkin lights & usb access just below the panel.

Tweaked a bit. Since the main holder bay that cradles the Tazer doesn’t actually rest against the mount bar anymore, there’s no harm in dropping it down for even easier access, yet within the reach of the wiring that connects to the Tazer. Also dialed in the clamp height and compression strength.