I have a set of four Molded Black fender flares with liners, still attached, and Halogen turn signals for sale. They are off of a 2020 JLU with 3600 miles. Near perfect condition. I did not remove them by the "Jerk" method as seen online, took the time to remove them properly.
They are ready...
Thanks Kevin. The rails are Rough County.
https://www.roughcountry.com/rc-jeep-wheel-to-wheel-nerf-steps-rcj1866.html?find=2020-jeep-wrangler-jl-unlimited-4wd-740607
I put 295/70-18 Nitto Ridge Grapplers on mine. That translates to a 34x11.50. Saves a little of the gas mileage. A Tazer JL is a must have for the shift points, still get 17.8mpg at 80mph. Wheels are 18x9 -12 and I do have the Mopar 2” lift So I’m not sure if they would rub.
Hi Benny,
I have a 2020 Sport Altitude with original incandescent turn signals. I bought LED's (55112884AF
55112885AF 68302119AB 68302120AB) that I want to install but am unsure of the correct P/N for the front fender flares that I need. Any help os greatly appreciated....
Thanks
Mike
For sure. I almost bought my first Jeep from them. They had a a “hail damage” page in the papers. They said there was no hail however when I got it home we found some. Took it back and they did not want to give me my deposit back. I called Amex and that was taken care of lol.
Another install tip. I just installed this today, took about 2.5 hours. I did not cut the inner fender plastic rivets or cut a gaping hole in the rubber grommet. Instead I used a glow-rod, put a light below and fed the glow down with wires attached, then took the glow and pushed from the inside...