Airaid part # 314-294 plus K&N pre-filter shown in pics. Only fits EcoDiesel in JT/JL.
Might need 1-3/4 hose clamp or reuse factory clamp.
Split washers/washers included, not shown.
This filter is the oiled version. Works with Dry filter, not included.
Price $150.00 plus shipping.
Great condition no rock rash.
The Power Steering cooler (Apex) is mounted underneath the winch protected by Skid plate.
Includes everything in the pics plus the winch blank plate, 4 Rivnuts to mount the Grimm Winch Mount to the factory horns and 2 Apex hose fittings with clamps.
Price $800.00...
Have a rear set of Rugged Ridge/BushWacker Hydro Form fender flares.
New never installed. I bought the set to get the front for my Gladiator.
$250 plus shipping. 87544.
Been awhile. I’ve been building the Gladiator the past year. Started some new modes for the trailer recently. Getting ready for what we hope to be many great camping adventures this year.
I’ll be posting updates on the Gladiator side.
Link attached...
Complete set of take off control arms. About 25k miles. The upper bushings need to be replaced. One new bushing included. Lower look ok, but probably should be replaced.
No rock rash or anything. Just discoloration. We towed a lot with these arms, bushings go quicker.
$200 OBO. You pay shipping...
So I have my axles. Started the build then FedEx lost my driveshafts… I went with 5.13. Going to run 40’s for the first set. Next 42’s.
I’m building at a friends shop. While waiting I’ve put over 600 miles on his JTRD running 42’s with 5.38 gearing. Drives close to a stock JTRD around town and...
I’ve owned 3 sets of Dynatrac axles, lots of Currie stuff (not axles). Both companies make good products.
For my JT build I had the same questions, which axle? I went with Fusion. I’ve always wanted a kingpin front and liked the attention to detail Fusion had for the build. Should see them any...