Search results

Very cool! I think I might have seen you on Instagram what's your handle?

I used a Flathead and lots of patience, they will come off if you get it at the right angle

Also looking for something like this

i just got my windshield replaced, went through insurance, safelite billed my insurance company $650

these come off very easily, the bar is left on, Counting Mars Fastening Tape Cable Tie Double-Sided, Self Gripping Multi-Purpose Hook and Loop Tape, Reusable, 2" x 8 Meter Roll - Black https://www.amazon.com/dp/B07R4Z4RTV/ref=cm_sw_r_em_apa_i_5HVtEbH0CYS2R

Nope. I Drive city and highway with a 50 mile commute everyday, of course I've only had the bags for two days but no noise. The bags are strapped to the l shaped bar with long velcro closures, no movement. I have an air pump, tire repair kit, recovery straps, and all odds and ends loaded up in...

The posts are actually a bit flexible so it could be that you would have your car seat sitting flush against the seat without the recline kit but I couldn't tell you that for sure because I have the recline kit installed, your idea about covering them with fabric is not bad I could even just put...

I took the head rest cushions off: https://www.jlwranglerforums.com/forum/threads/rear-headrest-removal.4332/page-4#post-1026066

Looks a bit odd with these 4 posts sticking up, you can see before and after headrest cushion removal. To remove the cushion you just need to undo the cover at the bottom of the head rest, then there are 2 spring clips holding the cushion in place, remove those and you just pull off thie...

THIS DOESNT WORK, the plate on the back of the rear bench seat is riveted to the frame (must be different on the gladiator), there is no way to access the headrest mechanism without cutting off rivets, that was one step too far for me lol, I DID however get the headrest cushions off and that...

That's what you're seeing in my photos, 2" self wrapping Velcro, works perfectly.

Just installed this divider yesterday. It was pretty straight forward, but, because I have the factory subwoofer, I had to cut off part of the netting. This is thoroughly explained in the instructions. I ordered direct from Dirtydog in Canada and it arrived in about 3 days to me in Queens, NY...

Actual pics of my install

My install, I couldn't get the top straps to work with my Maximus 3 brackets so I used my own straps.

Picture for clarification attached. Instead of using the top strap (red X in picture), I used a double sided Velcro strap (at the green arrow in picture)

Was hard to pull the trigger on these, but there's nothing else that is this good. if you want something quality I highly recommend. I would say the amount of room inside is 80% of the under floor compartment in the cargo area for each bag.

Just installed XG Gama bags and yes they work together with the maximus3 brackets, BUT the top strap is pretty much impossible to clip through the max3 bracket (it's sewn in place) Maybe there is some method for getting that done, but I couldn't figure it out. I ended up putting a Velcro strap...

I will update when I do mine. I installed the rear seat recline kit and I still need these head rests gone! https://www.jeepgladiatorforum.com/forum/threads/rear-seat-outboard-headrest-removal-process-from-fca-manual.22237/