Sponsored

Search results

  1. USB 1 Power Dash Cam

    According what i read, The juice from USB ports albeit low amps, is always on whether car on or not. How long USB port is powered after the car is turned off? It depends on the setting of the energy saving feature. Note that even if this feature is set to "off," the car does go into energy...
  2. CAN Bus fault codes - need help

    U codes are problems on the CAN - controller area network serial data bus. You check if there is a bad module or a wiring problem or not.
  3. Battery Dead at 6000 miles

    Have you found the answer yet? I have the same issue today and i try "resetting"the whole system by disconnecting the positive terminal on the battery for about 5 minutes and reconecting. It works. Try if it works for you.
  4. Rough idle at start and blinking check engine light

    Blinking check engine light is the car telling you something is seriously wrong, it may be misfiring. One of causes make engine misfiring that could be ignition control module. I think you should check it.
  5. Multiple Vehicle Recal Question

    Did you find any programmer that allow to use on two Jeeps yet? According what i searched, there is no and Superchips Flashcal can't use for multiple vehicles. Because the original tune is stored in the unit's memory. If you can find any programmer, just update for us know it.


Top