https://www.handyflag.com/product-page/handy-flag-kit
Folds down small. I keep it where the jack goes when not in use and have there quick disconnect setup front and rear.
Installed rock lights. (Lux Lighting) RGB 8 light kit.
Also finally got my rear 300M RCVs and installed them. ( Took 4.5 months to get) Front were done 5 months ago.
Last image is Top of the World trail in Moab at the top!
The 0 offset will set the tire out about 1 to 1.25 inches from the fender and if you have the extensions on the fenders like the extreme recon it will be about flush to the extensions.
Stock tailgate with NO reinforcment is good for about 85lbs...
Mounted our Badge of Honor badges with Hook and Loop to the AAL table molle.
Nothing sticking to the table so when we get more we can move them arround.
Upgraded front axels to 2 piece 300M RCVs.
Dynatrac Ball joints.
While in there replaced axel hub assembly.
ordered Artec trusses and C gussets front and rear and also ordered rear 300M axles from RCV.
I have what is pictured above on the top picture but with the JK version of the ATS (black and silver). Also make sure if you go to a nut or a hex bolt that you have clearance when you turn lock to lock. I did not have the room so ran with what is pictured up top.
Yes it can be made to fit.
I had one and ended up buying a new bolt from synergy that replaced the one for the trackbar and had a stud on the end and a screw to hold one end of the ATS and then bought a fox 1.5 clamp to go to my synergy tie rod and bolt the the ATS.
You just need to change the...
Diode dynamics sells a harness that goes from factory plug to the rigid lights SAE fog I use that is a legel fog light. Give them a call to get the correct harness. They may even make some for other brands. This all runs like it was from the factpry fog switch.
Worked on a few things this week.
American Adventure Labs Versa-table( anodized red to match Rubicon red dash), Mopar cold air intake, PSC big bore hydro assist and a winch kill switch.