I had the exact same experience as the OP. Total garbage and would never use them again. I spent countless hours between the dealer, a top notch race mechanic and another shop going back and forth.
I have 5 newly purchased NITTO Ridge Grappler's the new 38s... They are AMAZING tires, but unfortunately I must part with them. Only have 200 miles on them. Will ship - also Available for pickup in San Francisco if you want to save $$ ...
Paid $551 + tax new
PRICED TO SELL: $350 each. You...
I have 5 almost brand new 38ā Nitto RGās for sale
these are incredible tires. Bought them for my raptor but theyāre slightly too big.
my loss Is your gain.
$395 ($551 new)
Pickup in San Francisco or I will ship to you
message for details
LOL - had a few drinks today! Iām aware of the difference between tire and wheel sizes šš¼ š
at any rate Iām curious if folks have opinions about good alternatives to the Nitto trail grappler.
Iāve been running 37ā Nitto Trail Grapplers and loved them. Got some new wheels and wondering what a logical āupgradeā would be.
Looking to stay with 37ā (maybe 38)
This is for 2018 JLUR - 3.5ā lift. Not a DD- basically just a trail rig at this point.
looked at the Nitto M/T but those are...
i do. I pulled it out and the draw didnāt change much
what I was really curious about is why the draw shows 600-800ma at the negative battery terminal, but only 50-60 at the ground connection to the body (the recommended approach suggested in the other thread)
When I leave my Jeep for 2-4 weeks sitting without starting it Iām finding the battery is dead. If I leave it on a battery tender itās ok
Iām trying to locate the parasitic draw. Iāve disconnected the negative terminal from the battery and measured the draw with my multimeter and am seeing...
I installed these on my rear seatbelts on my Jeep JL. They look cool and prevent flapping but also seem to prevent the seatbelt from operating. The spiderwebshade mesh cover gets jammed up and i canāt pull the seatbelt without fiddling with it.
Did anyone else experience that? Is there a fix?
anyway Iād say I loved these sliders for a street rig / light crawling.Iāve turned my JL into a mostly dedicated trail rig now so Am switching to the metal cloak sliders
Wish I knew about the covers. I had never heard of them and canāt find them on the website. I always had small problems with the sliders not smoothly opening - RSE replaced one for free (excellent customer service TY). Also had a problem where the magnet sensors would sometimes get out of...
I have (Had) the rockslide engineering stepsliders installed on my JLUR- worked ok until I did the rubicon trail. Bashed them somewhat but not too hard. Both of them unusable afterward. Have used them on multiple trails before the rubicon - but that really did them in
I have the borla climber exhaust and tried to install this and it does not fit. The borla exhaust silencer hits the air compressor. Itās off by about 2 inches. I think it might be possible to cut the pipes and reposition the silencer further forward to clears the air compressor