I didn’t read all the responses but I am one that traded from a 2019 JLUR gas with a 2” lift, 37”s and armor to a 2021 diesel jtur. I have now taken both of them to Moab and run some similar trails. I only have a 1.5” leveling kit on the JT so not an exact comparison. They are both Jeep’s and...
I considered doing it with mine. I was going to put in a rotary potientiometer so I could manually adjust the maximum brightness and install it under the hood near the solid state relay. I figure once it was installed and adjusted I wouldn't really mess with it. Just make sure to get one...
Mine does not hiss much more than normal either. The turbo boost was a little more pronounced than stock but not like a fan blowing. To me that would seem like an air leak.
The lip of the stock valve that you are supposed to carefully pry up is extremely brittle. I tried to keep it in tact but there was no way. Honestly the gfb valve is so much more robust I won’t go back. If I need it more like stock I will remove the additional spring that the gfb valve comes...
I finally got mine installed yesterday. The lower boot was a Sonofabitch. With the boot preinstalled on the intercooler I couldn’t get enough movement to get the lip of the boot around the throttle body. The boot ended up getting some abrasion from the effort. After many different attempts I...
I appreciate your documentation of your self ramblings. I was searching for this same part and really appreciate that you have completed the leg work for it. I have ordered the GFS T9356 to install with the Mishimoto intercooler pipe.
Not to ruin anyones over/under but this forum member says he is picking his up tomorrow 12/31 on the 3.0 production page. So at least one will be delivered by the end of the fourth quarter.
@Mishimoto, sorry to report I have tripped the code again. Only a few short trips on the Jeep since last reset. This is with brass filter removed, 4800 ft elevation, air temp was 49 degrees. I am assuming this code will continue to trip more frequently as temperatures drop. Other than system...
To share some more data, I am running the catch can without the filter. Yesterday I went to a local resort for ocktoberfest. The drive started at 4800 feet and the parking lot was at 8000 ft. I did get the P2 code as a pending code while at that elevation. The code cleared and everything shows...
@Mishimoto I cleared my codes while doing electrical over Labor Day and decided to try one more week with the filter in. After a day I looked In the codes and had the p1 code pending. The next day it tripped the light. I decided to leave it alone and the light went off the next day but it...