JLUR 3.6 8spd
Granite Crystal
body color top and fenders
Black Leather, Both safety groups, cold weather, trailer tow, 8.4, proximity, keyless entry, front camera, led lights, steel bumper, top liner, mats
Ordered: 4/20
Paint: 4/29
Built 4/30-5/1
Shipped 5/1
Fresh off the truck 5/18
(almost...
JLUR 3.6 8spd
Granite Crystal
body color top and fenders
Black Leather, Both safety groups, cold weather, trailer tow, 8.4, proximity, keyless entry, front camera, led lights, steel bumper, top liner, mats
Ordered: 4/20
Paint: 4/29
Purchased a Borla climber touring (140828) and started install, but the exhaust is about 2" too long. Both hangers on the rear section end up behind the rubber isolators when the system is assembled (when the rear section is disconnected from the muffler, they fit fine) Anyone else seen this...
My experience-
Lifted JLUR (Mopar lift) 18, manufactured 3/18. Started getting the service locker light intermittently while wheeling, eventually started showing up more often. My code scanner showed a C144D code, pointing at the front locker.
Important to note that if you turn the...
I just disconnected the negative on the main battery, then disconnected the ess battery connection right at the negative terminal.
(the aux battery is connected to ground via the main battery terminal, removing the nut and second black wire from the negative battery terminal will disconnect...
Many store them by wrapping it around the end of the rope (near the hook) so that it will be available when the rope is pulled out, you only need to use it when the rope contacts the ground or a rock between you and whatever you are connected to.
Just had 5.13s put on my 18 6 speed, was getting ess warnings... encountered this post
https://www.jlwranglerforums.com/forum/threads/ess-broken-after-regearing.11852/page-2#post-541310
Did the battery disconnect and the warnings stopped, (I also did the top gear n/v relearn, but have not...
The Rockhard sliders I put on came with new hardware, the hardware I removed appeared normal, but still has all of the threadlocker on it, I would be hesitant to reuse it and obviously would clean them if I chose to.
Some observations from my Rockhard slider install on my 18 JLUR from today, (using suggestions taken from this topic, and the ace bolt video)
1. Use a 24"+ breaker bar, something long enough that you can be very smooth and not jerky, can feel the resistance increases, and be able to reverse...