Just wanted to put this out there as a warning to be wary of this and inspect your fuel lines. In now way am I knocking @Artec however hopefully they can look into this issue further and possibly take some action. To my knowledge I haven't seen anyone else have this occur to them however it only...
So, this is either a new issue or an existing issue but i just noticed it since i had my radio off. I am getting white noise when the jeep is on and radio is on mute. When i turn the wheel the noise gets louder and quieter. I checked with my dealer and he pulled my vin and i don't have the...
Wanted to see if anyone had any knowledge on these 2 parts.
Currently i am still using stock parts for these 2 and when wheeling my driveshaft is hitting them pretty badly. Was seeing if anyone had replaced these and if they have better cleareance of same/worse than stock? I am not concerned...
For those that have changed over to 60's and used a tazer jl to turn the e-locker and FAD off. After everything is said and done does the 4wd indicator in the gauge cluster still work for you? Right now the indicator for me has no indication what setting the transfer case is in
Rubicon Dana 44's front and rear. 4.10 Gears and factory e-locker - Asking 4500 for everything. Willing to sell axles alone and will provide you with factory yokes.
Includes Cavfab aluminum Tie rod / Drag link with Steer Smarts Rod ends
Motobilt front / rear diff covers and rear locker harness...
Came off Jeep JL
Set of 5
KMC XD231 17x8.5 4.75 Backspacing 5x127
Milestar Patagonia 37x12.5r17
All wheels have TPMS sensors works with JL and certain JK models.
Wheels have rock rash.
Tires do not have any plugs
Price - $SOLD
for local pickup only.
Tires are at 9/32-10/32
I recently installed the PSC steering and everything is working pretty good on the street. I ran some tests to check for clearances and ran into an issue where the pitman arm would hit the stock rubicon sway front sway bar when the front driver was at full droop and turned hard left.
My...
Getting all my ducks in a row and was wondering where everyone is trimming when going 40’s. Looking to see if I can still get decent uptravel with 3 inch bumps.
I know that the rear of the rear quarter will need to be trimmed but what about the top or front of the rear?
for the fronts, do I...
Selling a Teraflex EF2.2 Adjustable steering stabilizer.
Had it for about a year but it has been sitting in my garage after i went with Aluminum Tie rod
Asking Price - 160 OBO + Shipping
Has scrapes on the bottom but works flawlessly
Vision wheels 17x9 -12 4.5" BS 5x127 / 5x5
It has a replaceable rock ring which has some rock rash from them.
This is for a set of 5 without tires.
Asking 550 + shipping or best offer. Located in northern California
Here is how they looked like on the jeep and how much they stick out...
Getting close to pulling the trigger on a set of 60/60 Axles from Fusion 4x4.
Wondering if anyone on the forums have run them and what additional parts are needed besides driveshaft/wheels/wiring lockers.
Also wanted to see if anyone on the forum was running them at full width with low 3.5"...
Just finished up on doing the Hydro assist with the new PS pump / Reservoir / Steering Box.
I have factory axles with CavFab tie rod which are 1.75". At the same time i installed a Rusty's Track Bar Brace. Instead of having brackets welded onto the stock axles i went with Next venture...
I am attempting to install the inner fender liners for the rear however i ran into an issue. For the tabs that go into the body should there be rivnuts installed? My inner fender panels just have holes. There is no way for a nut/bolt to be installed. Any help would be greatly appreciated. Thanks...
I was hoping there would be someone who could help with my questions. I am interested in a Dometic CFX50w fridge with either a Dometic Slide or a DFG offroad slide.
Curious are you guys able to install your fridge and slide and still have the backseat up on the driver side?
Looking at the...
Just wanted to throw this out there to see if anyone else is interested in going to corral hollow. Its a mild to medium trail and it is currently open although there may be little spots of mud. This would be a day trip and has a decent overlook. I will most likely be starting from the north /...