Thank you for this. I figured as much. I installed them and got the error message, but the lights seemed to be working fine, so I ignored the error message. The message and blinker indicator speed on the dash are annoying, but so is the start/stop feature and the shift indicator on the dash...
So my left turn signal gives me an error and tells me that the left tail light is out. The right tail light seems fine. When I turn my left indicator, I get a fast turn signal light on the dash panel and the clicking sound is fast. However, the left turn signal works just fine, as does the...
@Rhinebeck01
I received my lights last night and installed them immediately. My Jeep came with the LED package so I didn't need the pigtail capacitors. Also, I don't have the side sensors, so didn't need to remove anything except the mounting bracket. Three screws and done. Took all of 10...
My daughter is a competitive figure skater and skates at several rinks in our area. This is the Zamboni at the Wake Competition Center in Raleigh, NC. I thought it was pretty cool and a brilliant marketing campaign.
It's just as bright as stock. There is no difference between the brightness levels. Even during the day, the brightness is excellent. I'll try to post a photo tomorrow.
It's not hard at all. Took about an hour total time. Hardest part is lining up the needle after install to make sure the MPH is accurate. It's a trial and error, so it's best to not re-assemble everything before making sure the needle is in the right position. I had to try three times before...
I installed my Daytona white gauge faces from US Speedo. Great quality. I had these on my 2008 JKUR and loved the look. These are even better quality and the numbers are crisp and clear at night.
I got the Motobilt Hammer and absolutely love it. The installation of the bumper was extremely easy and I was able to do it in about 45 minutes by myself. My Jeep has a set of Traxda 1.5" coil spacers up front and 1" coil spacers in the rear. Tires are 35x11.50 Toyo Open Country A/T III on...
Just installed a set of SS3 Pros in yellow in my Motobilt bumper. Used the same hardware as for the stock plastic Rubicon bumper. The fit was absolutely perfect and the quality of the parts is excellent. Everything feels beefy and solid. Connections were a breeze with the included pig tails that...
Absolutely. I’ve had them on for about 6k miles now and two wheeling trips. Holding up well and great on snow, ice, rain and all conditions. Like them as much as the BFG KO2s. More aggressive tread pattern is a little noisier on highways but not terrible.
This is a very personal decision and everyone will have an opinion based on their experiences. I'm 48 years old and I've always driven manual. It's the only thing preventing me from getting the 392. I had a 6.4L Ford Raptor and sold it because I missed driving stick. As much fun as the Raptor...
Did you swap out the control arms for stock? I'd put the stock arms back on and re-measure the adjustable arms. My guess is they are not even and your driver side axle is sitting further forward than your passenger side. Maybe you measured incorrectly, from center to center. Sometimes you...
Did you measure the coils before putting them on to be sure they shipped the correct springs? Manufacturers make mistakes and they may have shipped you one 2" coil and one 4" coil. I'd take them both off, set them on the ground and measure. Once you take them off, I'd start from scratch...
Just installed my Synergy sector shaft brace today. Very straightforward. Took about an hour total install time. My kit came with four new long bolts to replace the existing steering box bolts, but they seemed too short. The stock bolts were longer so I reused those same ones and torqued to...