Search results

Abbazabbalutely not one issue since replacing

Testing the water with you guys. I am considering modifying my hardtop which would make these fuel can inserts unnecessary. If anyone has any interest in something like this, these are a one off product. The cans are fuelpax 3.5 gallon. This is indeed a pair. *Admin, I'm curious about interest...

👍

Had to change my design. Those leaked a little thru the vent hole. An now using a manual push to vent fitting. No leakage, easily vents with push of finger. No picture tonight but will add one tomorrow.

ARB under custom rear platform

Experimenting on an ABS plastic top for back seat coverage when needed. I normally run the freedom tops only in acceptable weather. This would go on in 5 minutes and along with freedom tops keep 95% of the water out. First day fitting to a tube frame substrate not shown. The weight is...

Made two small 'L' brackets out of sheet metal and attached the front bar on one of the speaker bolts. (6 poles at the front can't be putting more than 1lb on front bar. 2lbs Max) Rear is just a spring tight fit into holes opposite seat belts.

Been a minute between posts. Moving to Colorado has been a really fun experience. Have been doing more fishing than anything else. Needed a way to carry all my fishing poles. Works like a champ!!!

Finished product

Updated progress. Complete minus knock in end caps and clear tubing I am going to put over each of the contact points. Last picture coming, with two bikes on it ready to roll.

This was today's start to this crazy idea I had about a swing away bike rack. I think it's gonna work out. Due to angles and using the existing tire carrier hole along with the shackle bracket on the other side it is not symmetrical. It simply drops in and will only be used carrying bikes so it...

57,000 plus miles and have not had any lurching or issues. Yes, the clutch is softer than any of my previous 15 or so clutch's. But, thrilled! Retrain your clutch leg and you'll be fine

57,876 miles in. 11 trips 3000 miles plus, and have not found it uncomfortable yet. Hope that works out for you.

No pictures until it comes off again. I simply spread the liner away from trim piece and slipped a small tiny screwdriver in and broke the back of the hole the rivet passes thru. Once the liner was out I just slotted the back of the holes in liner. Now it pulls out and slides back in after...

Aux battery took a dump today. Found a local duracell 220 cca exact fit. Front wheel off, lowered on jack, I had already modified the liner to come out simply for other wiring needs. From opening garage door upon return from bulbs and batteries to drive out to test. 44 minutes. I had...

I've gets looked at, cleaned regularly, driveshaft greased, axle ends gone over, fluids check, shocks rebuilt, air and oil service. Have even discovered a few other unnecessary rattles inside both the A and B pillar covers. ... ... .Those bolts, have eluded me! Until now at least.

I had an annoying rattle up above my head. Check your bolts holding your windshield. Two of those four bolts of mine had loosened up and the washer was just jiggling. Simple two minute fix.

Darwin award!

I have been told the Odessey PC680MJ is an acceptable ess battery. I cannot verify that. Can anyone else?