It's been on for a while. Just haven't bothered with a picture.
The fit of mine was actually pretty good. I had a friend hold it in place while i tightened the 4 screws.
I really like it. I did a very similar thing on my RAM for the switches and gauge for an air pump and air bags. People think it is factory. I bet you can fool people with yours.
I finally got my bumper. Apparently their powder coat machine burnt up and they had to replace it causing them to get behind.
The directions are total garbage.
Quality seems pretty good. I am satisfied.
You need to mount the brackets to the bumper loosely 1st. Tighten the 2 bolts that go from...
Thank you. I disconnected my batteries then reconnected them this morning. Then took a quit test drive and the light did not come back on. If it does again I will definitely contact my dealership.
The plastics trim stuck out a hair over 3/4 of an inch. The box is just a hair over 6 inches, so it sticks out approximately 5 and 1/4 inch further than the plastic trim would from center. 2 and 3/4 of inch from the hump with the data plate. These measurements do not include the lock and handles.