Search results

  1. ARB refrigerator installs

    I'm not exactly clear on your points, so let me try and take a shot at it. - The transition piece you're referring to is when the seat is folded flat(ish), it's the piece that covers the gap and hinges? If so, I have clothe interior, and I didn't have that transition piece or gap cover. Yes...
  2. Lower Your Trans Temps! Mishimoto R&D: 2018+ Wrangler JL Transmission Cooler

    Hello Steve, If you recall how the cooler mounts, there are two screws on the left side of the cooler (passenger side). One screws in from the front (this bracket), and the other screws in from the side. The bracket for the one on the side is what limits the cooler from moving to the right...
  3. ARB refrigerator installs

    It does stick up maybe about 1/8" of an inch, but it hasn't been an issue. This link should take you to where I got it from on Amazon. https://www.amazon.com/DPI-Marine-DPF1115BLK-Flush-Door/dp/B017NA9RRG
  4. Bare minimum tools for the trail?

    Unfortunately, that kit doesn't carry a lot of the stuff I do and need for my JL.
  5. Anyone using an Antirock Swaybar on their JL?

    The double-thick new arms I got are holding up fine. However, I've noted that right after I got those, the AntiRock kits that started shipping right afterward included the new cast chromoly arms. I don't know how those are holding up.
  6. Truss JLUR axles or go to Dana Ultimate 44?

    I got a Miller 211 MIG. I've found it so useful that I'm kind of mad that I didn't buy a years ago. I'm not sure of your gas situation, but can you rent the bottles from a local welding supply? Don't you already have a Rubicon? Maybe I missed something. I'm running Rubicon axles regeared with...
  7. Gear swap - Engine Whining

    The shop is brushing you off for their poor workmanship. Simply looking at the gears, they won't see the cause of the whine. They screwed up the install.
  8. Truss JLUR axles or go to Dana Ultimate 44?

    My opinion would be to take that $1500 and buy a welder and some scrap metal. Learn to weld, then weld your own trusses on. Though I bought my welder for a similar job, welding on the Artec trusses and C gussets wasn't that big of deal. Of course, it was a little easier with the front axle out...
  9. Lower Your Trans Temps! Mishimoto R&D: 2018+ Wrangler JL Transmission Cooler

    I finally got around to installing this. I knew it would be a pain because I needed to remove my winch, which meant I also needed to remove my front LP6 lights and bumper. Not a job I was looking forward to. But...my Warn winch died (motor full of water). Anyhow, while I was fixing the winch...
  10. King Bump Stops for the REAR

    I need to remove that washer, as the bump stop pad is slightly contacting it. I had already remove one on the other side, as there was a little more contact, and it was leaving marks on the bump stop pad. I should also add for anyone looking to install these, is that there can be very tight...
  11. King Bump Stops for the REAR

    I know what you're referring to. I've heard it when doing faster sweeper turns on rough dirt roads, but I can't say it's been objectionable on the street or around town. I might hear it once in a while. Of course, it really depends on the suspension setup and ride height from the bump stops, as...
  12. ARB refrigerator installs

    Yes, the Redarc isolates the fridge battery from the vehicle battery. That's one of the nice things about this setup, is that you're not butchering the stock battery setup at all (e.g., Genesis). You can kill the fridge battery dead, dead, dead...then start your Jeep and start charging the...
  13. Trail Hero 10/6/20

    That is completely understandable. I'd have had a hard time with that as well, especially if I were in the same situation having just been social distancing elsewhere. Still a bummer, though, but there will be more events in the future, and Sand Hollow will always be there.
  14. Mojave Road - open to advice and tips

    I haven't been out there yet in my Jeep, but I want to do that route with the family sometime soon. Yes, we "overland" - or car camp - with a family of 5. Maybe toward the end of October or beginning of November? I have ridden that area quite a bit on motorcycles some time ago. Before you get...
  15. Rubicon -> Sport axle swap. Blinking locker light? Switches for lockers?

    Yes, when the sensor goes bad, it sends the wrong signal to the system, causing the light to come on and stay on, along with other lights and restrictions (Rubicon sway bar control). There are a few options to get a premade harness for the Rubicon axle. Just power and ground is all you need to...
  16. JLUR locker issue after new gears, truss, rcv shafts and FAD delete

    Most likely, they didn't install the locker sensor plate correctly. This is a very common problem for installers who aren't familiar with this. There's a plate that the sensor looks at that must be removed and installed in the exact same position. It's not marked at all, so it's easy to just...
  17. Rubicon -> Sport axle swap. Blinking locker light? Switches for lockers?

    You're putting Rubicon axles on a Sport? Well, just an FYI, the Sport doesn't have lockers, so there are no locker lights to come on. This is a complete non issue. All you have to do is apply power to the locker. You're not going to be using the sensor signal at all - heck, you're not likely to...
  18. Lower Your Trans Temps! Mishimoto R&D: 2018+ Wrangler JL Transmission Cooler

    I know that. But anyone else who purchases the cooler won't find a link to that in the instructions. I was commenting on the instructions. And though while he said that was from the service manual, it was abbreviated, and didn't include all the necessary information that needed.
  19. Lower Your Trans Temps! Mishimoto R&D: 2018+ Wrangler JL Transmission Cooler

    So many of you probably heard that the Gladiator has grille inserts that flow more air than the Wranglers. Apparently, according to the parts catalogs I've looked through, the 2020 Wranglers come with these inserts as well, so no need to change them on this year model.
  20. Lower Your Trans Temps! Mishimoto R&D: 2018+ Wrangler JL Transmission Cooler

    I just received the transmission cooler today. Of course, no instructions are included, but there was a piece of paper that said to go to the website. Once you get there, good luck finding the instructions. They really need to fix that - well...the website is pretty horrible. Good luck even...



Advertisement
Top