Sponsored

Search results

  1. SAVE 10% on all products now through Cyber Monday! 813 Fabrication & Design

    No code needed, all products are 10% off now through 11:59pm on Cyber Monday! Compressor mounts, accessory mounts, MOLLE panels, etc. https://www.813fabrication.com/
  2. I just swapped the Mopar H6 battery to the larger H7 Duralast Platinum. The negative terminal seems small.

    I just swapped the Mopar H6 battery to the larger H7 Duralast Platinum. The negative terminal seems small. I cannot tighten down the neg terminal enough, it stays loose. Anyone had this issue? Should I use a shim on the terminal or return the battery for an H6?
  3. New! - Under the Front Seat Compressor Mount for JL/JT

    Our new Under the Front Seat Compressor Mount is now available!! Designed to hold the ARB twin or single compressors as well as most ViAir compressors. The mount is made of 1/8” powder coated aluminum. No cutting of the carpet or plastic air vent is required. Depending on what floor mats you use...
  4. Driver Side Fender Under Hood ARB Single Compressor Mount

    The Driver Side Fender Under Hood ARB Single Compressor Mount is another ARB compressor mount that we offer. Works with 3.6L & 2.0 Non-eTorque Engines. DOES NOT fit Diesel, 4xe or eTorque engines. Keep in mind, the compressor slightly rubs the hood liner of the Rubicon hood, see photos. Jeep...
  5. ARB Single Compressor Underhood Firewall Mount

    Designed to mount the ARB Single Compressor, model CKMA12. Included with the kit are: Compressor mounting plate and firewall mounting brace. We also offer an add-on fender air kit which includes air coupler, air hose, air fittings and fender plate for mounting the rocker switch and air coupler...
  6. Rear Gate Air Compressor Enclosure for ARB Twin/Single or ViAir Compressor & MOLLE Panel

    We are always trying to add more options for onboard air! Check out our new Rear Gate Compressor Enclosure & MOLLE Panel! Made from 1/8" aluminum with black texture powder coat. The base replaces the plastic rear gate body panel and will hold the ARB twin or single compressors as well as most...
  7. Dead Pedal with a little extra!

    Check out our all aluminum dead pedal... it has a little extra! You can option the pedal with an "Old School" floor dimmer switch or a momentary switch. With the "Old School" switch you can control off-road lights very easily while keeping both hands on the wheel and both eyes on the road! It...
  8. etorque start-stop not working after removing engine battery

    Does anyone know if there is a reset for the start stop system? I have removed the engine battery a few times while working on some items. The first time the start stop starting working again after driving some but now after taking the battery out again it isn't working after driving for a few...
  9. Wiring Baja Designs LP6 lights to an on/off rocker switch?

    Hello, I ordered two sets of LP6s, one for my JT and one for my Wife's JLU. I ordered the kit with the upfitter harness not realizing that this kit it for using the AUX switches. We do not have the AUX switches in the JLU. But, I was going to wire them to an on/off switch and not use the AUX...
  10. Rockslide Engineering steps on 22 JLUXR? Do you have to trim for eTorque model?

    Has anyone installed RockSlide Engineering sliders/steps on a JLU with eTorque? There is an extra bracket under the passenger side and I think I will need to trim the slider to fit. Thoughts?


Top