Search results

  1. What did you do TO your Jeep JL today?

    Hi Mate, i am planning to install the same Cable Gland for my Solar Panel (and light wires). Would you mind sharing few photos from inside the jeep to show how it looks? also did you use your drill bits for the cable or used hole saw for a larger intake? I have 3 pair of cables going through...
  2. Extra fuel

    Nothing significantly different with the side mount, it doesn't stick out much from the rear fender flares.
  3. Extra fuel

    Yes I did. First accessory I bought, after signing the order document for my JL in feb-19. Got it delivered 6 months before the JL finally showed up. this days I use this for potable water (as got the long range tank installed). You can mount shovel/maxtrax etc. not a big fan of roof rack...
  4. Extra fuel

    hahah, 54.2 gallons total
  5. Extra fuel

    Yes correct, I got the 3.6L. I believe the aux tank for the diesel is still under development and will be smaller in size (45L). your best bet for now will be the trailrax solution. They are very handy, love mine. Just checked the spec of trailrax again. It can carry 30L in each side for a...
  6. Extra fuel

    I got the long range tank (64L) as the auxiliary tank + Trailrax rotopax side mount for another 30L. if I really want then I can go as high as 175L (81+64+30).
  7. Baja Designs are Not JL Rubicon Install Friendly with their Harness

    Sure! as i mentioned earlier, i wanted high beam to come on with the factory high beam signal/stalk, that being the default option. With this scenario, i couldn't connect the LP9 Pro directly to the high beam cable as this will not provide enough amp for both factory headlight and the LP9 Pro's...
  8. Baja Designs are Not JL Rubicon Install Friendly with their Harness

    Thank you for the reply. got it sorted, needed 2 set of relay for my use case. cant wait to try it out with my next trip!
  9. Baja Designs are Not JL Rubicon Install Friendly with their Harness

    I finally got my pair of LP 9 Pro's (had to wait over 2 months for shipping to Australia) I also got LP9 pro harness (64-0172). Below is my plan for wiring: - Factory Aux (1) On = Low Beam On - High beam steering wheel stalk On = High Beam On (also turns off low beam) High beam can be turned...
  10. Livernois ECM Tune for Wrangler JL V6 3.6L (Australia)

    I Also thought E85 would be cheaper vs 93 (98 RON). Its about 22% more expensive add 30% loss in efficiency for E85, you are looking at a significant price vs performance gap for E85. I am almost done with my 1st fill of 140L of E85, will move to 98 next week, hopefully the experience will be...
  11. Antenna size and mounts

    I bought this Pod Light Mount from Amazon and repurposing it for the antenna. it's stick out few cm on the passenger side of the Jeep, reception have been decent so far, no issues...
  12. Livernois ECM Tune for Wrangler JL V6 3.6L (Australia)

    Well..Livernois recommends E85 to get the best HP/Torque out of this tune. I believe with 98 you loose few HP. I found the engine does run few degree cooler with E85. Two reason I want to move to 98 1) E85 is hard to come by and expensive, about 30 cent more 2) I am getting 21.4L/100km with the...
  13. Livernois ECM Tune for Wrangler JL V6 3.6L (Australia)

    I should have been bit more clear. Before the ECM swap i was running 98 RON. Literally as soon as i swapped the ECM i filled my tank with E85. Based on my limited understanding if you swap fuel (between ethanol and non ethanol) the engine need few KM of driving to get used to the new fuel. The...
  14. Antenna size and mounts

    I installed my antenna on the passenger side crawl mount. the 2.2 dbi antenna also sticks out few CM as the tallest point of my Jeep, perfect for measuring those pesky carpark entrances! And for the head-unit, i installed it under the steering wheel column, i was surprised to find a "Perfect...
  15. Livernois ECM Tune for Wrangler JL V6 3.6L (Australia)

    I wrote the below in the tuner section, posting again in the local section as i know few of us in Australia were looking for a tuner for the JL Wrangler. Here is my review of Livernois Tune for Wrangler JL v6 3.6L after using my Wrangler JL for 380km with the tuned ECM Swap. Disclaimer: Below...
  16. Review - Livernois Mycalibrator Tune for Jeep JL 3.6L V6

    As promised, here is my review of Livernois Tune for Wrangler JL v6 3.6L after using my Wrangler JL for 380km with the tuned ECM Swap. Disclaimer: Below review is my personal opinion of the Livernois Tune after testing it for one week. Any comments made against and or for are not to be taken...
  17. Aux switch ideas for JL/JT

    Thank you! Thank you!
  18. Aux switch ideas for JL/JT

    Hi Jaydee, I am trying to setup a relay so my aux light comes on when I turn on high beam. I see you got yours setup similar, did you had to splice a wire at the headlight assembly? if yes which one? or at fuse box to trigger the high beam. any help or a photo would be highly appreciated!
  19. Review - Livernois Mycalibrator Tune for Jeep JL 3.6L V6

    Only had it for 24 hours and will load the Transmission tune now..and my verdict is... Will let you know in a week time, the last think i want to do is comment about such a "Significant Mod" just after having it for 24 hours and 50km of drive....
  20. Fender Vent Blackout Decals

    Short answer is Yes, look you are getting the “Black” decal for the “Look” as this part of the decal stands out when you look from any distances and does look really good on Red. On other hand the Red highlights give you that blend look with the Rubicon decal specially so when you are close by...



Advertisement
Top