If I have a Rubicon with the premium sound system meaning the subwoofer back there what interior parts do I need to change out to make the one work on the driver side? I thought I had the part numbers from a thread running around here but they turned out to be wrong and where do you get them cuz...
The Evo kit uses a king shock that is actually a 14-in travel shock. My rig is actually higher than I want but everything's custom on mine because I have aftermarket axles and I did not use any of the brackets that were on there I do a lot of snow Wheeling so it's good to be a little bit higher...
I called Kelvin he took my number down that's the last I heard of him I'm going to call him this week because I haven't heard anything but my advice is if anybody is experiencing this they should call PSC and get it on some kind of a list or call him once a week so that we can get this resolved.
thanks man I really needed this information so if I get that right then the sub is about a 200 w sub with four voice coils so if I added a sub that was four ohm then I would be getting half of that so basically what I'm hearing you say is I need to bypass that amp and get my own.
What are you guys recommend as far as speakers? Not talking brand I'm going to go with Hertz but component or non component? I realize this amplifier has a crossover in it but does that work when you're hooked out to RCA's? and if you use this head unit are you bypassing the built-in amp if you...
on the ud60s in the rear end did you use the stock brackets to come onto ud60s and the coilovers and the sway bar links fit? Can you post more detailed pictures of those areas near the brakes and the bracketry thank you, nice setup by the way.
I only want to do this once so I'm going to wire up a Kenwood five-channel amp about the same as just buying a straight sub amp and using the head unit.
I'm going to run Hertz speakers all the way around except for the sub is going to be JL 10-in. I really like the way it Hertz sounds.
Talk to stinger is 25 watts RMS per channel 50 Watts peak so basically I need to add an aftermarket amp. now I just have to do some research to figure out how to tap into those speaker wires so I don't have to run new ones cuz I'm not going to go over 50 Watts RMS.
It would be really nice if that SD card slot for mapping could be used for storage.
Thanks for all the replies.
I noticed that some video say it's 50 watts per channel and some say 25 watts per channel what is it?