Search results

  1. Rough Country with DRL / JL Aux Switches

    Yes to all. I know it was obvious by looking at the switch. I can check in a little while after I get through my morning meetings...
  2. Rough Country with DRL / JL Aux Switches

    I did. I don’t have the colors handy but I just chopped off the switch and grounded the ground, one wire to one aux Wire and the last wire to the other aux wire...
  3. What did you do WITH your Jeep today.

    Peru Creek, Cinnamon Gulch, and Chihuahua Gulch yesterday.
  4. Building the Wee Beastie

    Took her out to Chihuahua Gulch, Peru Creek and Cinnamon Gulch this past weekend...
  5. Spied 2 Ford Broncos in Dillon, CO Today

    The one I saw was completely un-camoflauged. By the time I got the camera out, I just got a dusty back.. Not going to lie. It was VERY pretty coming at me...
  6. Spied 2 Ford Broncos in Dillon, CO Today

    Saw a black one on Cinnamon Gulch trail. Probably the same folks.
  7. Colorado LED Fog Lights -100

    Yeah. The bumper is headed to TX. Dogs are still available.
  8. Smittybilt Stryker bumper - help

    they are oculus leds. The stock steel bumper led mounts didn’t work with the bumper mounts.
  9. What did you do TO your Jeep JL today?

    a) a fellow Delawarean! I’m from Millsboro! b) did you bed line a perfectly good JL? I’m not judging because I’ve bedlined vehicles before, but note it was always because it would hide imperfections... I’m more than curious.
  10. Smittybilt Stryker bumper - help

    Also, if you are replacing headlights, do that before winch install :)
  11. Smittybilt Stryker bumper - help

    it’s a rough country with DRL. As for the spacer, it’s just a flat rectangle that goes on between the frame horns and the main winch plate thing.
  12. Smittybilt Stryker bumper - help

    Closer pics... passenger side.. drivers side...
  13. Smittybilt Stryker bumper - help

    I don’t think there is any difference in the size of the two winches. Note that the Clearance issues I had were more to do with the grill than the fogs. Make sure you use the spacers that comes with the bumper. It’s not in the instructions...
  14. Smittybilt Stryker bumper - help

    i have this bumper and I replaced the steel bumper. My fogs did NOT fit. I have a gen 3 9.5 and I was able to get the fogs in. Highly suggest doing it before putting the main part of the bumper on though and definitely before the skid. Ask me how I know.
  15. What did you do TO your Jeep JL today?

    No. Honestly, I wasn’t a fan of how the RGB worked. I thought about doing a whole rgb setup with the fogs, rock and interior lights on Aux Switches. The thought being that I would just use the aux switch for turning them on and off assuming they remembered the last color they were on. The...
  16. No Lift Off-Roading People

    Me too. I’m old enough that 15 minutes added to either end of my trail run is worth it for comfort.
  17. No Lift Off-Roading People

    hmm. Does aired down matter? If you air down the top of the tire still has most of the air while the bottom might flex more... I guesss it would matter because aired up, there is some ballooning that goes on which may make it bigger than when aired down... although with belts, that is probably...