calliejake
Member
- Thread starter
- #1
Any suggestions for getting the front track bar actually into the axle side bracket? It's too wide....
Sponsored
I had to use a pry bar and carefully spread the bracket just slightly to get mine in.Any suggestions for getting the front track bar actually into the axle side bracket? It's too wide....
Same, better than it being too loose.I had to use a pry bar and carefully spread the bracket just slightly to get mine in.
Me too, no big deal, I’d much rather it be tight than looseCresent wrench worked for me.
Thanks - the pry bar worked - was a little nervous bending a bracket. Next question, any ideas for the brake line brackets? Seems it would have been easier to "peel" them off when the bracket was still installed to the lower control arm...I've bent the crap out of it with channel locks, but can't get it "open" enough to get the brake line out...cut off wheel?Any suggestions for getting the front track bar actually into the axle side bracket? It's too wide....
I cut them with a dremel. Took long enough.. If I hadn’t had a “few” barley pops at that point, an angle grinder with cut off wheel may have been quicker.Thanks - the pry bar worked - was a little nervous bending a bracket. Next question, any ideas for the brake line brackets? Seems it would have been easier to "peel" them off when the bracket was still installed to the lower control arm...I've bent the crap out of it with channel locks, but can't get it "open" enough to get the brake line out...cut off wheel?
I've installed a TJ and a JK lift in the last 6 months, but this one is throwing me...