shekmark
Well-Known Member
- First Name
- Mark
- Joined
- Jul 21, 2019
- Threads
- 26
- Messages
- 584
- Reaction score
- 443
- Location
- Manasquan, NJ
- Vehicle(s)
- 2018 JLUR
- Occupation
- Yes
- Vehicle Showcase
- 1
- Thread starter
- #1
Sponsored
It depends on if you have the Tazer JL, or the Tazer JL Mini/Lite version. All of them require you to reach up about 6” above the part in your picture (which is the OBD port) where you will see two smaller plugs. Unplug those and plug them back into the Tazer Mini/Lite, or if you have the Tazer JL there is a part that those plugs go into.I just looked under my dash for first time because my new Tazer is still in the box. Is this the port it plugs into ?
See my compare install here https://www.jlwranglerforums.com/forum/threads/tazer-smart-stop-start-showdown.21707/ i know you have the lite but the lite module plugs in the same as the bypass moduleThanks. I got the lite. I will look up there higher. Its off to the side like this port but higher.
Yes, directly above there, about 6” higher behind the dash. Right where the metal brace is, that is going to hinder you in getting those plugs out!Thanks. I got the lite. I will look up there higher. Its off to the side like this port but higher.