Luca_CH
New Member
- First Name
- Luca
- Joined
- Jun 11, 2019
- Threads
- 0
- Messages
- 4
- Reaction score
- 3
- Location
- Lugano Switzerland
- Vehicle(s)
- JL Rubicon
Hello, i search this bumper, someone know the brand?
Luca
Luca
Sponsored
Maverick - I have the same rear bumper but with the led lights. Install was fairly easy. I thought getting the EAG installed was easier than taking the stock plastic bumper off! I have the license plate relocation kit and it works well. Also have the third brake light relocation kit which I'm not in love with. I'll be changing that out as I want to put the brake light where the license plate is. I may modify the EAG plate bracket to accept the light or get the LOD relocation kit. No sure yet. I have no rattle while driving. As Maverick stated, time will tell how the bumper holds up but for now, it's very good.Here is a pic of the EAG full width rear bumper/tire carrier setup installed. First though review on it. Texture coating isn’t as. I’ve as my rugged ridge front full width bumper but that’s ok I can live with that. Tire carrier is supposedly rattle free so far without driving my Jeep around with it on I can shake the carrier and it rattles a little don’t think I’ll even notice it while driving. Tire carrier latch seems nice but the handle its self is plastic hope it lasts. The bumper didn’t come with a license plate relocation bracket. But did come with the camera wire extension which seemed good quality so far. The instructions are not the best. Leaves a lot of Important information out but for persons with any mechanical knowledge can figure it out. Relocation for camera wire is just sticky pads and zip ties. I’ll be drilling and taping proper straps. In the next couple weeks when I find something I like. Over all satisfaction of the bumper is seven out of ten so far. Price was only 600 bucks for the full setup. That is also factored into the 7/10 review
Looks like a Smittybilt if I'm not mistaken. It never occurred to me that it's possible to customize the little addon pieces with color like that, very cool.Hello, i search this bumper, someone know the brand?
Luca
I found it. it’s a GoRhinoLooks like a Smittybilt if I'm not mistaken. It never occurred to me that it's possible to customize the little addon pieces with color like that, very cool.
Ah good to know. Smittybilt also does the little extra accents that come apart like that which is what made me guess. Theyve got a similar shaped one I want to called Stryker but it's a stubby now that I looked at it.I found it. it’s a GoRhino
I just ordered mine how is the installation?Rugged Ridge Arcus bumper installed today.. just need a winch
Very straightforward, good instructions. The only issue I had was a little bit of powder coat in the threads of the nuts that hold the fog light brackets it. I had to use a long ratchet to get enough leverage to “rethread” them with the bolts. Not too big of a deal.I just ordered mine how is the installation?
Did your front skid plate work with the bumper or did you trim/remove it ?Rugged Ridge Arcus bumper installed today.. just need a winch
No, I am going to try to modify it. It’s close, maybe a dremel will do the trick.Did your front skid plate work with the bumper or did you trim/remove it ?
Installed it! Awsome!Very straightforward, good instructions. The only issue I had was a little bit of powder coat in the threads of the nuts that hold the fog light brackets it. I had to use a long ratchet to get enough leverage to “rethread” them with the bolts. Not too big of a deal.
Nice! Did you add the wire mesh in the winch cutout? Mine did not come with that.Installed it! Awsome!