WilhelmSR
Well-Known Member
- Thread starter
- #1
I wanted a mount the creates a protective barrier for the housing and the USB port. Grabbed my Tazer and calipers, and after an hour in CAD, a couple of hours of test prints later, and finding things to change after each prototype. I have this for my JL made of ABS. Has a clip to keep the unit in the housing but also very easy to remove when you want to update the firmware.
If I have time, I will make a few dozen to take to NJ Jeep Invasion in July if anyone wants one. Material cost is only like $0.40 so not worried about making any money (I'll never turn down a beer though lol.). Just figured I would share with those that would like one.
If I have time, I will make a few dozen to take to NJ Jeep Invasion in July if anyone wants one. Material cost is only like $0.40 so not worried about making any money (I'll never turn down a beer though lol.). Just figured I would share with those that would like one.
Sponsored
Last edited: